Jwin JT-P433 - Manual (Page 11)

Vintage Design Telephone with Caller ID V10M10_IM_EN_01282008
www.jWIN.com - 10 -
OPERATIONAL INSTRUCTIONS
Basic Setup-continued
L. SET DIALING MODE
- When the LCD displays “DIAL MODE”, press the SET/BACK button to
enter.
- Press ▲ UP or ▼DOWN to select the desired dialing mode. ‘TONE’ for
tone dialing and ‘PULSE’ for pulse dialing
- Press the SET/BACK button to confirm
Note: Under the pulse dial state, press the Star button to change to tone dial.
M. SET VOICE TARGET NUMBER
The voice target number is very useful when you are not at home/office to pick
the call. After setting the voice dialing number, the phone will announce “please
call XXXXXX (the setting number)” after five (2 ) ringing sounds.
- When the LCD displays “TARGET NUMBER”, just press the desired
number (at most 16 digits)
- Press the SET/BACK button to confirm
N. SET VOICE REPORTING ON/OFF
- Under off-hook state, press the Star button for three (3) seconds to enter
the setting.
- Press the Star button to choose “VOICE NUMBER/ON” or “VOICE
NUMBER/OFF”
- If you select “VOICE NUMBER/ON”, the phone will announce the
incoming number twice. Select “VOICE NUMBER/OFF” to disable the
function of voice reporting
O. SET CALL FORWARD TO VOICE MAIL
- Under off-hook state, press “＃” for three (3) seconds to enter the setting
- Press “＃” to choose “CALL FORWARD/ON” or “CALL FORWARD/OFF”
- If select “CALL FORWARD/ON” and there is any incoming call, the phone
will announce the voice target number (please refer setting point M) three
times after 2 ringing sounds.
P. SET CALL FORWARD TO EXTENTION LINE
- Under off-hook state, press the SET/BACK button for 3 seconds, the LCD
will display “OFF” and “- -“
- Press ▲ UP or ▼DOWN to select “ON”
- Enter one or two digit(s) from 0-9, Press ▲UP or ▼DOWN to select
desired number (Press the SET/BACK button to confirm the first digit and
then set the second digit)
Note: If you want to set “OFF” from “ON”, under off-hook state, press the
SET/BACK button for 3 seconds and the LCD will display “ON” and “- -“. Then
press ▲UP or ▼DOWN to select the “OFF”
Q. MUSIC ON HOLD FUNCTION
- Under off hook state (Pick the phone or during speakerphone in use
status), press [HOLD] to enter music on hold status
- The LCD will display “HOLD” and “-01-” , press ▲UP or ▼DOWN to
select the music hold melody from 01-04.
- Press HOLD again to recover the conversation
Note: During the incoming call, if press HOLD once, the ringing sound will be
turn off immediately. However, it will resume the ringing sound in next
incoming call.