JVC RX-8012RSL - Manual (Page 24)

21
From the remote control:
1. Press the source selecting
button (DVD, CD, TV/
DBS, CDR, or TAPE/MD)
*
for which you want to
change the input mode.
Note:
* Among the source listed above, you can select the digital input
only for the sources which you have selected the digital input
terminals for. (See “Digital Input (DIGITAL IN) Terminal Setting”
on page 19.)
2. Press ANALOG/DIGITAL INPUT
to change the input mode.
• Each time you press the button, the
input mode changes as follows:
When playing a software encoded with the Dolby Digital or
DTS Digital Surround, “DGTL AUTO” may not happen to
work well. In this case press CONTROL UP
5/DOWN ∞ on
the front panel to select “DGTL D.D” or “DGTL DTS” (while
“DGTL AUTO” remains on the display).
Note:
You can select “DGTL D.D” or “DGTL DTS” from the remote control by
using the On-Screen Menus (see page 40).
DVD MUILTI DVD
USB
CD
CDR
TAPE/MD
TV/DBS VIDEO PHONO
FM/AM
VCR 1 VCR 2
INPUT
ANALOG/DIGITAL
ANALOG DGTL AUTO
(Digital)
When playing a software encoded with the Dolby Digital or
DTS Digital Surround, “DGTL AUTO” may not work properly
and the following symptoms may occur:
• Sound does not come out at the beginning of playback.
• Noise comes out while using the searching or skipping
chapters or tracks.
In this case press CONTROL UP
5/
DOWN ∞ to select “DGTL D.D” or
“DGTL DTS” while “DGTL AUTO” still
remains on the display.
• Each time you press the button, the input
mode changes as follows.
When selecting “DGTL D.D” or “DGTL DTS,” following
indicators showing detected signals light up on the display.
: Always lights up.
When selecting “DGTL D.D”
DIGITAL : • Lights up when Dolby Digital signals come in.
• The frame flashes when Dolby Digital signals
are not recognized.
When selecting “DGTL DTS”
: • Lights up when DTS Digital Surround signals come in.
• The frame flashes when DTS Digital Surround
signals are not recognized.
Note:
When you turn off the power or select another source, “DGTL
D.D” and “DGTL DTS” settings are canceled and the digital input
mode is automatically reset to “DGTL AUTO.”
To change the input mode back to analog input, select
“ANALOG” in step 2.
DGTL AUTO DGTL D.D
DGTL DTS
(Digital)
(Digital Dolby Digital) (Digital)
CONTROL
DOWN UP
EN11-27.RX-8010&8012R_f 01.3.19, 1:57 PM 21