JVC RX-8012RSL - Manual (Page 29)

26
On the front panel:
1. Press PTY SEARCH while
listening to an FM station.
“PTY SELECT” flashes on the display.
2. Press CONTROL UP
5/DOWN ∞
until the PTY code you want
appears on the display, while
“PTY SELECT” is flashing.
The display gives you the PTY codes
described to the right.
3. Press PTY SEARCH again, while
the PTY code selected in the
previous step is still on the display.
While searching, “SEARCH” and the
selected PTY code alternate on the display.
The receiver searches 30 preset FM stations, stops when it finds
the one you have selected, and tunes in that station.
To continue searching after the first stop
Press PTY SEARCH again while the indications on the display are
flashing.
If no program is found, “NOTFOUND” appears on the display.
From the remote control:
1. Press PTY SEARCH while
listening to an FM station.
“PTY SELECT” flashes on the display.
2. Press PTY + or PTY – until the
PTY code you want appears on the
display, while “PTY SELECT” is
flashing.
The display gives you the PTY codes
described to the right.
3. Press PTY SEARCH again, while
the PTY code selected in the
previous step is still on the display.
While searching, “SEARCH” and the
selected PTY code alternate on the display.
The receiver searches 30 preset FM stations, stops when it finds
the one you have selected, and tunes in that station.
To continue searching after the first stop
Press PTY SEARCH again while the indications on the display are
flashing.
If no program is found, “NOTFOUND” appears on the display.
PTY codes
Travel
Affairs
Rock M (Music)
Religion Easy M (Music)
Children Classics
Finance
Weather
Other M (Music)
Social
Phone In
Light M (Music)
Info (Information)
Sport
Educate (Education)
Folk M (Music)
Oldies
Drama Nation M (Music)
Culture
Jazz
Varied
Pop M (Music)
Country
Science
Leisure
Alarm !
TEST
Documemt
None
News
When an emergency broadcast (Alarm ! signal) is sent from an
FM station:
The receiver automatically tunes in the station except in the
following cases:
• When you are listening to non-RDS stations (all AM — MW/LW
and some FM stations).
• When the receiver is in standby mode.
While receiving an emergency broadcast, “Alarm !” appears on the
display.
The TEST signal is used for equipment test — whether it can
receive the Alarm ! signal correctly.
The TEST signal makes the receiver work in the same way as the
Alarm ! signal does. If the TEST signal is received, the receiver
automatically switches to the station broadcasting the TEST signal.
While receiving the test signal, “TEST” appears on the display.
PTY SEARCH
CONTROL
DOWN UP
PTY SEARCH
PAUSE
PTY SEARCH
SET
FF/
PTY
/REW
PTY
PAUSE
PTY SEARCH
SET
EN11-27.RX-8010&8012R_f 01.3.19, 1:58 PM 26