Jackson 700 Series - Manual (Page 19)

GAS LINE
Remove the 3/8” flare fitting that
attaches th
Manifold blo
of the pedestal
and plac
Natural Ga
Part # NGH
REMEMBE
FITTINGS
ALL
CO
FIT
BU
,
SAF PE
MAINT
e propane hose from the
ck inside
re e with an approved 10’
s Hose neoprene hose.
OSE
R TO LEAK CHECK ALL
AND ORIFICES AFTER
OF THE CONVERSION IS
MPLETED, LEAK CHECK ALL
TINGS AND TEST FIRE ALL
RNERS TO ENSURE PROPER
E O RATION.
ENANCE
Bur
Ins
er ically cleaned using a small piece
wire and a wire brush. Be careful not to damage the ceramic spark electrode. Have the burner replaced if
ere are any signs of deterioration.
AL FOR CLEANING
ner pection: Please inspect these burners once a year.
P iod inspect the burners for blockage or corrosion. These burners can be
of
th
BURNER REMOV
1. Ensure
cool.
2. Remove
vor Shields.
3.
ocated at the very back of burner near the rear of the firebox.
4. Remove
angle. Repeat for all burners.
5. Clean t
he burners with a Brass Bristle wire brush and make sure all gas ports are clear.
se a straight coat hanger to clear any obstructions.
6. nturi end of the burner to chec
straight coat hanger to clear any obstructions.
rner and removing the venturi shutter. Once removed, make sure the burner is thoroughly cleaned and
the venturi shutter is re-installed with an opening of 1/8” for Natural Gas and ¼” for Propane. (NOTE:
ensure that the venturi set screw is tight after setting the correct air shutter opening.
8. Re-install and secure burner.
9. Re-mount flame tamers and cooking grids.
10. Light each burner to ensure they are operating correctly.
Note: When installing burners, it is very important to center the burner over the gas orifice. You should look
under the main control panel with a flashlight once installed to make sure they are in the proper position.
Failure to clean and install burners correctly could result in fire or explosion.
Remove
Propane hose
and regulator
assembly and
Install new
Natural gas
Hose
the gas supply is off and grill is
Cooking Grids and Upper Fla
Remove the burner mounting screw l
burners by lifting up and out of firebox on an
he outside of t
U
Use a flashlight to look into the ve k for blockages. If necessary, use a
7. Inspect and clean the venturi end of the burner by removing the venturi set screw on the end of the
bu
19