GE 24927 GE Universal Remote - Manual (Page 7)

6
Programming For VCR
Most GE, RCA and ProScan VCRs will not
require programming. Check to see if your
VCR responds to the remote before you
begin programming.
1. Manually turn on the VCR. Find the
three digit code for your VCR in the code list
below.
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release the
VCR button (The INDI-
CATOR LIGHT will
blink then remain lit.
4. Enter the code using
the Number Buttons.
After your code is
entered, the INDICA-
TOR
LIGHT will turn off. If
the code is not valid, the
INDICATOR LIGHT
will blink. Check the
code list and repeat
process.
5. Aim the remote at
your VCR and press the
ON•OFF button. Your
VCR should turn off.
NOTE: If your VCR does not respond, try all
the codes for your brand. If the codes do not
work, or your brand is not listed, try the
Code Search method.
6. With your VCR on, press CHAN+
(CHANNEL UP). If the VCR responds, no
further programming is required.
7. Enter your code here for easy reference.
VCR CODE
CHAN +
ON•OFF
1 2 3
4 5 6
7 8 9
0
(OFF)
(BLINK)
INDICATOR
LIGHT
VCR
SETUP
24927 Revised Size 7" x 2 3/4" 8/19/03 9:10 AM Page 7