GE 24927 GE Universal Remote - Manual (Page 8)

7
Programming For DVD
Most GE, RCA and ProScan DVD systems
will not require programming. Check to see
if your DVD system responds to the remote
before you begin programming.
1. Manually turn on the DVD system. Find
the three digit code for your DVD system in
the code list below.
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release the
DVD button (The INDI-
CATOR LIGHT will
blink then remain lit.
4. Enter the code using
the Number Buttons.
After your code is
entered, the INDICA-
TOR
LIGHT will turn off. If
the code is not valid, the
INDICATOR LIGHT
will blink. Check the
code list and repeat
process.
5. Aim the remote at
your DVD system and
press the ON•OFF but-
ton. Your DVD system
should turn off.
6. If the DVD System responds, no further
programming is required.
NOTE: If your DVD does not respond, try
all the codes for your brand. If the codes do
not work, or your brand is not listed, try the
Code Search method.
7. Enter your code here for easy reference.
CODE LIST
DVD CODE
ON•OFF
1 2 3
4 5 6
7 8 9
0
(OFF)
(BLINK)
INDICATOR
LIGHT
DVD
CODE
SEARCH
24927 Revised Size 7" x 2 3/4" 8/19/03 9:10 AM Page 8