Jensen JCR-255 - Manual (Page 10)

SETTING THE CLOCK
In case the back-up batteries are accidentally removed. You will need
to set the clock manually.
If the LED display is blinking
1. In standby mode, press the UP button to increase or press the
DOWN button to decrease the minutes setting.
2. Press and hold the UP / DOWN button to fast forward/backward
the clock setting.
3. Press the BAND/SET button or waiting 5 seconds to confirm the
setting.
If the LED display is steady
1. In standby mode, press and hold BAND/SET button for 3 seconds,
AM or PM indicator flashes
on LED display,
2. Press the UP button to increase or press the DOWN button to
decrease the minutes setting.
3. Press and hold the UP / DOWN button to fast forward/backward
the clock setting.
4. Press the BAND/SET button again to confirm.
NOTE
There are AM and PM indicators located in the left-hand corner of the clock
display. Be sure to observe the correct AM / PM indicator when setting the
alarm to make sure the wake time is set correctly for AM or PM.
1. Switch AUX IN / RADIO selector to select radio mode.
2. Press the ON/OFF button once to turn on the unit, display shows
FM or AM frequency for 5 seconds.
3. Press the BAND/SET button once to select AM / FM band.
4. Rotary the TUNING control knob to select your desired radio
broadcasting station. Display will return to show current time after
tuning control idle for 5 seconds.
5. Adjust VOLUME control to your desired listening level.
9