Jensen JCR-255 - Manual (Page 11)

6. When you have finished listening, press the ON/OFF button once
to turn off the unit.
TIPS FOR BEST RADIO RECEPTION
AM - The AM antenna is built inside the radio. If AM reception is weak,
change the position of the unit until the internal antenna picks up the
strongest signal.
FM - If FM reception is weak, fully extend the wire antenna and vary the
position and location of the antenna until you find the strongest signal.
ALARM OPERATION
SETTING THE WAKE UP TIME
This unit has Dual Alarm function. Each ALARM can be set to wake
to RADIO or ALARM. To set alarm time:
1. Press and hold ALARM1 or ALARM2 button for 3 seconds to enter
the ALARM setting mode, LED shows the default alarm time 12:00
AM and the ALARM1 or ALARM2 indicator flashing on the display.
2. Press UP / DOWN button to adjust minutes of you desired ALARM
time. Press and hold the button for fast forward / backward setting
the alarm time.
3. Press ALARM1 or ALARM2 button again to confirm the ALARM
time setting.
4. Press ALARM1 or ALARM2 repeatedly to select wake to ALARM
(bUZ) , RADIO (rAd) or turn off the alarm.
CHECKING THE WAKE UP TIMES
Whenever you want to check the wake up time, simply press and hold the
ALARM 1 or ALARM 2 button for 3 seconds. The display will change from
current time to wake up time. Release the ALARM button, it will return to
current time after 5 seconds.
WAKE TO RADIO
1. To select wake to radio mode, press the ALARM button you want to set
repeatedly until display shows “
rAd ”.
2. Release ALARM button and waiting about 5 seconds to confirm.
NOTE: 1. Ensuring a desired radio station is tuned and proper volume
is set.
2. If you set the AUX IN / RADIO switch to AUX IN position,
buzzer alarm will sound instead of radio.
3. The radio will automatically turn on and ALARM indicator flashing when
alarm time is reached.
4. The radio alarm will keep sounding for 60 minutes and then automatically
shut off until same time on the following day.
10