Jensen JCR-255 - Manual (Page 12)

5. To stop the alarm immediately, press the ON/OFF button once. The
radio will stop but the alarm remains set and will turn the unit on again
at the same time on the following day.
6. To turn off the alarm completely, press the ALARM button repeatedly
until ALARM indicator turns off.
WAKE TO BUZZER
1. To select wake to buzzer mode, press the ALARM button repeatedly
until the display shows “bUZ”.
2. Release ALARM button and wait about 5 seconds to confirm the setting.
3. The buzzer alarm will automatically turn on and the ALARM indicator
will flash when alarm time is reached. It starts softly and becomes
gradually louder.
4. The buzzer alarm will keep sounding for 60 minutes and then automatically
shut off until same time on the following day.
5. To stop the alarm immediately, press the ON/OFF button once. The
buzzer alarm will stop but the alarm remains set and will turn the unit
on again at the same time on the following day.
6. To turn off the buzzer alarm completely, press the ALARM button
repeatedly until ALARM indicator turns off.
NOTE: If you set the second alarm and it is reached while the first alarm is
sounding, the second alarm will sound and cancel the previous
alarm.
SNOOZE OPERATION
You may active the SNOOZE function manually after the alarm sounds by
pressing the SNOOZE button. The snooze time can be adjusted from 1 ~
30 minutes, the default snooze time setting is 9 minutes.
SNOOZE TIME SETTING:
1. In standby mode, press and hold SNOOZE for 3 seconds, the display
shows current snooze time and flashes.
2. Press the UP / DOWN button to increase / decrease the snooze time.
3. Press the SNOOZE button again to confirm.
SNOOZE FUNCTION
1. When the ALARM sounds, press the SNOOZE button to pause the
ALARM. The ALARM will come again after your pre-set SNOOZE time
is reached.
2. When the Snooze time starts, press the SNOOZE button again to check
remaining time left.
3. This manual snooze operation can be repeated again and again.
11