JVC DZ-VCA1SE - Manual (Page 17)

17
Mode control section
1 SOURCE switch
[CAMERA]
Outputs signals from the camera to the monitor.
[BAR]
Outputs an internal colour bar signal from the unit to the
monitor.
[TEST SG]
Outputs an internal 100% WHITE square screen from
the unit to the monitor.
Use to adjust for 100% WHITE and the aspect ratio of
the monitor.
2 FREEZE button
Press the FREEZE button to engage the Field Still mode
and press it again to restore the normal mode.
The status is shown by the LED at the left of the
FREEZE button.
LED lit : Field still
LED extinguished : Normal use
3 POSI/NEGA switch
[POSI]
Set to this position for ordinary operation.
[NEGA]
Outputs inverted red, blue and green signals from the
camera to the monitor.
4 DATE & TIME switch
[ON]
The date and time are shown in the upper right corner of
the screen.
[OFF]
The date and time are not shown.
MODE
CAMERA TEST SG
POSI NEGA
ON OFF
BAR
FREEZE
DATE & TIME
MODE
CAMERA TEST SG
POSI NEGA
ON OFF
BAR
FREEZE
DATE & TIME
MODE
CAMERA TEST SG
POSI NEGA
ON OFF
BAR
FREEZE
DATE & TIME
MODE
CAMERA TEST SG
POSI NEGA
ON OFF
BAR
FREEZE
DATE & TIME