JVC DZ-VCA1SE - Manual (Page 20)

20
Preparation
Installing a lens
This unit is not provided with a lens.
A special C mount type lens with flange back of 28.0 mm
can be used with no adapter. To use a 1/2" bayonet
mount type lens, an optional adapter (GL-V62U) is
required.
Reference
For your reference, examples of lenses that can be used
with the adapter are listed in the table below.
1/2" bayonet mount type lens
Manufacturer
Fujinon
Lens type
MSF10B
MSF75B
MS8X12B
MSF20B
MSF35B
• Consult your lens dealer for information on install-
ing and using your lens.
• Make sure the lens is screwed all the way in.
Otherwise, back focus cannot be obtained.
Installing the camera control unit (when installing in a rack)
The camera control unit is provided with screw holes on
its side panels to allow installation in an EIA 19" rack.
1.
Remove the screws securing the rubber feet and
detach the rubber feet (four positions).
2.
Install the inner members for the slide rails on the
side panels of this unit.
3.
Install the outer members for the slide rails on the
rack. Slide the unit into the rack.
Slide rails from the following manufacturer can be
used.
Model name
C-305-20
Manufacturer's name
Japan Acuride Co., Ltd.
Slide length
508 mm (20')
• For information on the installation of the outer
members and rack, consult the slide rail manufac-
turer or your dealer.
3
44
56.6 111.1 114.3
6-M4
Screw hole size
Inner member
Inner member
6 screws with a diameter of 4 mm
and a length of less than 6 mm
Inner member installation
Inner member installation
hole position dimensions
(Unit: mm)
PUSH OPEN
CAMERA CONTROL UNIT DZ-VCA1U
POWER CAMERA
ON
OFF
I
O
GAIN SHUTTER WHITE BALANCE MENU MODE
t = 3 mm
9.8 mm
6.5 mm