JVC RK-C42WBT3 - Manual (Page 9)

9
<Instructions for Assembly, cont’d>
Adjusting the Angle of the Plasma Display
The angle of the Wall Mounting Unit can be adjusted to 0
°
, 5
°
, 10
°
, 15
°
, and 20
°
.
1. Adjust the angle of the plasma display.
Brace the upper middle part of the plasma display with one hand and push the Angle Adjustment Lever to the
left with the other hand. The plasma display will tip forward. Release the Angle Adjustment Lever when the
desired angle setting is reached.
Caution
Grip the plasma display firmly while adjusting the angle, as the display could tip over and cause
injury.
2. Fix the Angle Adjustment Lever.
Once the plasma display has been set at the desired angle, fasten the Angle Adjustment Lever with the screw
(M5X20) r .
Check to make sure that the Angle Adjustment Lever is securely fastened and the plasma display does not
rattle and loose.
Note: do not fasten the Angle Adjustment Lever if the power cord or system cables have yet to be attached.
r Screw (M5X20) x 1
Angle Adjustment
Lever