JobSite Systems LSO-7 - Manual (Page 6)

INDOOR INSTALLATION
1. LSO speakers can be mounted either
horizontally or vertically.
2. Use the stud locator to identify the
location of the studs in the proposed
mounting locations of the speaker.
3. Mark the stud edges, using masking
tape.
4. Repeat this process for the other
speaker.
5. You may decide to adjust the speaker
mounting locations based on how
symmetrical the studs are located in
the wall space.
6. Use a pencil and the mounting
bracket to mark the locations of the
mounting holes on the wall.
7. Drill pilot holes into the mounting
surface.
8. If the mounting holes lines up with a
stud, use screws to secure the
bracket to the wall.
9. If the mounting holes do not line up
with a stud, secure the bracket to the
wall using anchors designed to
support the weight of the speaker.
10. Strip 1/4" of insulation from the end
of each wire.
11. Tightly twist the end of each wire
until no frayed ends remain.
12. Attach the speaker wires to the
speaker terminal connectors.
Connect the negative output from
the amplifier to the black terminal.
Connect the positive output from
the amplifier to the red terminal.
13. Remove the bracket knobs from the
speaker.
14. Slide the speaker into the mounting
bracket.
15. Insert the knob through the bracket
and into the threaded insert in the
cabinet.
16. Secure the speaker in place by
tightening the bracket knobs.
17. Repeat this procedure for the next
speaker.
OUTDOOR INSTALLATION
1. LSO speakers can be mounted either
horizontally or vertically.
2. Determine the appropriate mounting
location.
3. Use a pencil and the mounting
bracket to mark the location of the
mounting holes on the surface.
4
Figure 4
DS00386ATW_LSO-5_6_7_8.qxp 11/18/04 7:22 PM Page 4