John Lewis JLBIOS609 - Manual (Page 51)

51
What to do if
…
Problem Possible cause Remedy
The oven does not heat up The oven is not switched on Switch the oven on
The clock is not set Set the current time on the clock
The required settings have not
been set Check the settings
The oven’s automatic cut-out has
been triggered. See Automatic cut-out
The fuse in the house’s electrical
wiring (fuse box) has been
tripped Check fuse. If the fuses trip repeatedly,
please call an authorised electrician
The oven lighting is not
operating The oven bulb is faulty Change the oven bulb
The oven is not heating up.
Time
is lit.
Demo mode is on. Keep Time functions button pressed
for 2 seconds, then within 2 seconds
press and hold Time functions and
buttons for 2 seconds
The pyrolysis function is not
working (“C1“ is shown in
the time display) Side rails/oven shelf runners have
not been removed Remove side rails/oven shelf runners
The pyrolysis function is not
working (“C3“ is shown in
the time display) Door not properly closed or
door lock defective Close door properly
F2 appears in the clock
display Door not properly closed or
door lock defective Close door properly;
Turn the appliance off and on again via
the house fuse or the safety switch in
the fuse box;
If displayed again, please contact the
Customer Care Department
An error code not listed
above appears in the time
display Fault in the electronics Switch off the appliance via the house
fuse or the safety switch in the fuse
box and switch it on again
If displayed again, please contact your
local Service Force Centre