JVC HDTV Encoder DM-JV600U - Manual (Page 18)

18
There are 2 ways to start the encoding. One is to start the encoding automatically and the other one
is to start it manually by setting the menu.
Operation Flow Chart Display Flow Chart
The default setting of the
Start Mode item is set to
“Auto” in order to start the
encoding automatically.
☞
Page 13 “Start Mode
item”
The encoding can be man-
ually started or stopped if
the Start Mode item in the
menu is set to “Manual”.
☞
Page 19 “Start the
encoding manually”
HDTV ENCODER
DM-JV600U
I n i t i a l P a r a m M e n u
> C o n t r o l M o d e : L o c a l
I n i t i a l P a r a m M e n u
> S t a r t M o d e : A u t o
I n i t i a l P a r a m M e n u
> S t a r t M o d e : A u t o
I n i t i a l P a r a m M e n u
> S a v e & R e b o o t ?
Starting the Encoding
POWER
ON
OFF
POWER
FAULT
MULTI FORMAT HIGH DEFINITION TELEVISION ENCODER
ENTER ESC
Display 8 / 9 / ; / :buttons
ENTER
button ESC
button
Start the encoding automatically
Press the ENTER button
Display the Initial Param Menu screen according to
steps 1~5 on Page 16 “How to Change Menu Setting”.
Press the 8 / 9 buttons
Select the Start Mode item and press the ENTER but-
ton.
Press the 8 / 9 buttons
Select the “Auto” and press the ENTER button.
Press the ESC button
Press the ENTER button
The encoding will start after the menu setting is saved
and reboot of this unit is performed.
Memo Memo
Memo Memo
. . N o w I n i t i a l i z i n g . .