Jwin JDVD760 User Manual
Page 13
Portable DVD Player with 7” Active Matrix TFT LCD V11M11_IM_EN_05302008
- 11 - www.jWIN.com
GETTING STARTED
Location of Controls-Remote
1. POWER BUTTON
2. VOLUME BUTTONS
3. REPEAT BUTTON
4. MENU BUTTON
5. SUBTITLE BUTTON
6. PLAY BUTTON
7. TITLE BUTTON
8. AUDIO BUTTON
9. PAUSE/STEP BUTTON
10. F.BWD BUTTON
11. F.FWD BUTTON
12. ANGLE BUTTON
13. ZOOM BUTTON
14. DISPLAY BUTTON
15. SETUP BUTTON
16. SCREEN ON/OFF
BRI/COL BUTTON
17. NUMERIC BUTTONS
18. CLEAR BUTTON
19. STOP BUTTON
20. ENTER BUTTON
21. NAVIGATION BUTTONS
22. SLOW BUTTON
23. NEXT BUTTON
24. PREV BUTTON
25. SEARCH BUTTON
26. PROGRAM BUTTON
Replacing the Battery in the Remote Control
The remote control battery has been previously installed and ready
for operation for the first time use. When the remote control stops
functioning, replace the battery with a new one. To do so, locate the
battery compartment and follow the steps below:
1.
Slide out the battery holder from the remote control case.
2.
Insert a “CR2025” 3V lithium battery making certain to follow
the correct polarity. Observe the corresponding symbols (+/-).
3.
Secure battery and push the battery holder back into the remote control until it is fully
inserted.
When not in use – Remove the battery if the unit will not be used for several months or more.
Notes on battery usage - To prevent battery leakage, which may result in bodily injury,
property damage or damage to the unit, follow these instructions:
a. Install all batteries correctly according to the polarity (+/-) as marked on the unit.
b. Do not mix old and new batteries, carbon and alkaline, etc.
c. Remove batteries from the unit when the device will not be used for an extended period
of time.