Jwin JDVD760 User Manual
Page 18
Portable DVD Player with 7” Active Matrix TFT LCD V11M11_IM_EN_05302008
- 16 - www.jWIN.com
OPERATIONAL INSTRUCTIONS
Speaker Setup
The Speaker Setup options are illustrated below:
• DOWNMIX
o
LT/RT: Choose this setting when connected
to a 2-channel analog audio
input.
o
STEREO: Choose this setting when the
DVD player is connected to a TV
or modulator.
Basic Playback Operation
Place a disc in the tray. Playback will start automatically.
1.
ADJUSTING THE VOLUME
Press the VOLUME+ button to increase the volume or the VOLUME – button to reduce
the volume.
2. SKIP
FORWARD/BACKWARD
Press the NEXT SKIP or PREV SKIP buttons once to skip a chapter (on a DVD) or track
(on a VCD/CD) forward of backward.
3. FAST
FORWARD/BACKWARD
During playback (CD/DVD/VCD), press the F.FWD button or F.BWD button on the remote
control or press and hold the F.FWD button or F.BWD button on the main unit to scan
forward or backward on the disc. Speed increased at X2, X4, X8, or X20 normal speed.
Press the PLAY button to resume normal playback.
4. PAUSE/STEP
FUNCTION
During playback, press the PAUSE/STEP button to pause. While in Pause mode, press
the PAUSE/STEP button to play one frame with each press. Press the PLAY button to
resume normal playback.
5. STOP
During playback press the STOP button to stop playback. Press the STOP button to
activate the Resume function so that when the PLAY button is pressed, the playback will
resume at the same place where playback stopped. To disable this function, press the
STOP button again.
6.
SLOW MOTION PLAYBACK (DVD/VCD)
During Playback, press the SLOW button to decrease the playback speed to 1/2 normal
playback speed. Press the SLOW button repeatedly to decrease the speed as low as 1/7
normal playback speed. Press the PLAY button to resume normal playback.
7. REPEAT
During playback, press the REPEAT button to repeat one chapter/title or repeat all (for a
DVD), or to repeat a track or all tracks (on a VCD or CD) or to repeat sections between
two points (A-B).
Note: The Repeat function only works on VCDs in the PBC OFF mode.