JVC HR-DD840U - Manual (Page 55)

EN
55
SPECIAL FEATURES
TV Multi-Brand Remote
Control
The VCR's remote control can control several functions on JVC
remote control TVs and on the brands of remote control TVs
listed below.
The TV brand code is factory preset to control JVC TVs.
1 2
4 5
3
6
8
0
7 9
POWER
ENTER
TURN ON THE TV
1
Turn the power on using the TV's remote control.
SET REMOTE CONTROL
MODE
2
Set the TV/CABLE/DBS/VCR switch on the VCR's
remote control to TV.
SET TV BRAND CODE
3
Refer to the chart below. While holding down POWER
on the VCR's remote control, enter your TV’s brand
code using the NUMBER keys, then press STOP.
Follow the example shown at bottom left.
● Once you have set the remote control to operate the
TV, you don’t have to repeat this step until you
replace your remote control’s batteries.
● PANASONIC has two codes. If the TV does not
function with one code, try entering the other.
OPERATE TV
4
First, press POWER on the remote to see if the TV’s power
goes off as it should. If it does, try other operations.
● The POWER, TV/VCR, CH5∞, VOL +/– and
NUMBER keys on the remote can all be used to
operate the TV. *For some brands of TV, you must
press ENTER after having pressed the NUMBER keys.
● To return the remote to VCR control, set the TV/
CABLE/DBS/VCR switch to VCR.
NOTE:
Depending on the kind of TV, there may be cases where some
or all functions cannot be operated using the remote control.
CH
TV BRAND NAME BRAND CODE
JVC 01
MAGNAVOX 02
MITSUBISHI 03
PANASONIC 04, 11
RCA 05
SHARP 06
SONY 07
TOSHIBA 08
ZENITH 09
HITACHI 10
SAMSUNG 12
SANYO 13
SEARS 13
TV/CABLE/DBS/VCR
(Ex.) To set remote control to RCA 05:
5 STOP
POWER
0 Release
Hold
down Press in succession
STOP
NUMBER
TV/VCR
VOL. +/–