JL Audio Stealthbox SB-GM-SLVCTR2/10W3v3/TN - Manual (Page 3)

SB-GM-SLVCTR2/10W3v3_INSTR_SKU#011248 SB-GM-SLVCTR2/10W3v3_INSTR_SKU#011248
C O N G R A T U L A T I O N S
You have completed the installation for this model!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 1 4
Secure the bolts and nuts that were removed in
STEPs 8 & 9.
Secure the plastic covers that were removed in STEPs 2 & 3.
S T E P 1 3
We do not recommend the use of this center section to be
used as a seat. You can remove the seat belt latch as an extra
precaution.
S T E P 1 2
Place the supplied lock washer and then flat washer onto the
supplied bolt.
Tilt the seating back.
From under the center seat section, place the bolt assembly
through a factory hole and into the threaded insert of the
Stealthbox®. This hole can be viewed in STEP 7, circled.
Secure the bolt assembly to the Stealthbox®, do not over
tighten.
Page 3 • JL Audio, Inc 2007
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU#011248-09-06-200 JLA-SKU#011248-09-06-2007 7 • Printed in USA • ©2007 JL Audio, Inc. • U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign
patents pending. For more detailed information please visit us online at www.jlaudio.com.
(954) 443-1100 w w w . j l a u d i o . c o m
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y • M I R A M A R , F L O R I D A • 3 3 0 2 5 • U S A
I N C L U D E D H A R D W A R E
(1) (1) 3/8-inch -16 x 1-1/4-inch Hex Bolt 3/8-inch -16 x 1-1/4-inch Hex Bolt
(1) (1) 3/8-inch Lock Washer 3/8-inch Lock Washer
(1) (1) 3/8-inch Flat Washer 3/8-inch Flat Washer
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed) Acoustic Suspension (sealed)
Driver Type: 10W3v3 10W3v3
Nominal Impedance: 4 ohms mono 4 ohms mono
Continuous Power Handling: 300 Watts 300 Watts
P O W E R R E C O M M E N D A T I O N P O W E R R E C O M M E N D A T I O N
JL Audio recommends using a high quality amplifier such as the JL Audio 250/1v2.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the 250/1v2
when being used to power your Stealthbox
® .
The JL Audio 250/1v2 is a very versatile audio component. Please consult the owner’s manual for even more
detailed information about installing and tuning this amplifier.
M I D / H I G H F R E Q U E N C Y D R I V E R F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of you vehicle.
Front Speaker Size / Location: 6.5-inch / Front Doors 6.5-inch / Front Doors
Fits JL Audio Models: TR650-CSi, TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi, TR650-CSi, TR650-CXi, VR650-CSi, VR650-CXi, XR650-CSi, XR650-CXi,
C5650, C5-650x & ZR650-CS C5650, C5-650x & ZR650-CSii
Rear Speaker Size / Location: 5.25-inch / Rear Door 5.25-inch / Rear Door
Fits JL Audio Models: TR525-CXi, VR525-CSi, VR525-CXi, C5-525, C5-525x & ZR525-CS TR525-CXi, VR525-CSi, VR525-CXi, C5-525, C5-525x & ZR525-CSii