JVC RM-C1450 - Manual (Page 24)

24
Quick Setup
In auto tuner setup, the TV automatically scans through all available channels, memorizing the
active ones and skipping over blank ones or channels with weak signals. This means when you
scan (using the C
HANNEL +/– buttons) you will receive only clear, active channels.
è To choose "Cable or "Air" (or "Skip" when
you skip "Auto Tuner Setup")
π† To Scan Mode
è To choose Auto, STD, HRC or IRC
† To "Start"
Press the O K button
Auto Tuner Setup
When the setup is finished, "Thank you ! Setup is now complete." is displayed. Your quick
setup is now complete. You can now begin watching your television, or you can continue
on in this guide for more information on programming your remote control, or using the
JVC onscreen menu system to customize your television viewing experience.
Notes:
• You can choose Scan Mode only when Tuner Mode is Cable.
• If you want to cancel the Auto Tuner Setup, press the M
ENU button.
• Noise muting will not work during Auto Tuner Setup.
• If you choose "Skip", it finished without doing the Auto Tuner Setup.
Cable Users: After your auto tuner setup is complete, you may, (depending on the type of
hookup), have only 1 channel, usually 3 or 4 in the auto tuner memory. This is normal.
BACK
Back
MENU
Exit Select
Auto Tuner Setup
Tuner Mode
Scan Mode
Cable
Auto
Start
Operate
OK
Now Programming...
8
LCT2275-001B-A English.indd 24 LCT2275-001B-A English.indd 24 6/14/07 10:33:47 AM 6/14/07 10:33:47 AM