JVC RM-C1450 - Manual (Page 41)

41
Auto Tuner Setup
The auto tuner setup function is described on page 24 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M ENU button
π† To "Tuner Setup"
è To enter
π† To "Auto Tuner Setup"
è To enter
è To choose "Cable" or "Air"
π† To "Scan Mode"
è To choose "Auto", "STD", "HRC" or "IRC"
† To "Start"
Press the O K button (Programming will take serveral minutes)
The auto tuner is finished when the message "Programming Over !" appears onscreen.
BACK
Back
MENU
Exit Select Operate
Tuner Setup > Auto Tuner Setup
Tuner Mode
Scan Mode
Air
Auto
Start
– +
Notes:
• When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"
• If no channels were found using Auto Tuner Setup, check your antenna cable and the
settings for Tuner Mode/Scan Mode.
• You can also access the "Front Menu" screen by using the M ENU button on the side of the TV
instead of the remote control. Choose "Auto Tuner Setup" by pressing M ENU † on the side
panel and enter by using the C HANNEL +/- ( è ) buttons.
Tuner Setup
LCT2275-001B-A English.indd 41 LCT2275-001B-A English.indd 41 6/14/07 10:34:20 AM 6/14/07 10:34:20 AM