Jonsered LM2153CMDA User Manual

Page 3

Advertising
background image

22

Cleaning of air filter. Slacken the screw, remove the lid and

remove the filter cartridge.

Reinigung des Luftfilters. Schrauben lösen, Deckel abnehmen

und Filtereinsatz herausnehmen.

Nettoyage du filtre à air. Desserez la vis, enlevez le capot et

retirez la cartouche filtrante.

Limpieza del filtro de aire. Soltar el tornillo, quitar la tapa y extraer

el elemento filtrante.

Het schoonmaken van het luchfilter. Draai de schroef los, verwijder

de deksel en haal het filter eruit.

Pulizia del filtro. Allentare la vite, togliere il coperchio ed es-

trarre il filtro.

Over time, ground speed may decrease. Adjust as follows:

• Rotate nut (1) on the underside of the housing to tighten cable.

Ground speed should increase.

If ground speed remains the same, drive belt is worn and should

be replaced.

Mit der Zeit kann die Geschwindigkeit abnehmen. Regulieren

Sie diese wie folgt:

• Drehen Sie die Mutter (1) an der Gehäuseunterseite gedrückt

um den Riemen zu straffen. Die Grundgeschwindigkeit sollte

so zunehmen.

Verändert dieses Verfahren die Geschwindigkeit nicht, ist der

Transmissionsriemen defekt und muss ersetzt werden.

Après un certain temps, la vitesse de roulement peut diminuer.

Veuillez l’ajuster de cette façon:

• Tournez le écrou (1) situé en dessous du châssis pour ten-

dre le câble d'entraînement. La vitesse de roulement devrait

augmenter.

Si la vitesse de roulement demeure inchangée, la courroie du

système d’entraînement est usée et doit être remplacée.

Con el tiempo, la velocidad con relación al suelo puede reducirse.

Ajustar del siguiente modo:

• Rote tuerca (1) en la parte inferior del bastidor para tensar

el cable impulsor. La velocidad con relación al suelo tendría

que aumentar.

Si la velocidad con relación al suelo permanece invariada, la correa

de transmisión está desgastada y se tiene que sustituir.

De basissnelheid kan mettertijd afnemen. Corrigeer dit op de

volgende manier:

• Draai de Moeren (1) onder de behuizing in en houd deze

ingedrukt om de kabel te spannen. De basissnelheid moet

toenemen.

Als de snelheid dezelfde blijft, is de drijfriem versleten en dient

deze te worden vervangen.

Nel tempo, la velocità rispetto al suolo potrebbe ridursi. Eseguire

le seguenti regolazioni:

• Ruotare la dado (1) posizionato sulla parte posteriore del

telaio da serrare il cavo. La velocità rispetto al suolo dovrebbe

aumentare.

Qualora la velocità rispetto al suolo non cambi, significa che

la cinghia di trasmissione è usurata e dovrà essere quindi

sostituita.

1

3

I. Training

• Read the instructions carefully. Be fa mil iar with the

con trols and the proper use of the equipment.

• Never allow children or people un fa mil iar with the

ins truc tions to use the lawnmower. Local regulations

may restrict the age of the operator.

• Never mow while people, especially children, or pets

are nearby.

• Keep in mind that the operator or user is responsible

for accidents or hazards occurring to other people or

their property.

II. Preparation

• While mowing, always wear sub stan tial footwear and

long trousers. Do not operate the equipment when

barefoot or wearing open sandals.

• Thoroughly inspect the area where the equipment is to

be used and remove all objects which may be thrown

by the machine.

• WARNING - Petrol is highly flammable.

- Store fuel in containers specifically de signed for this

pur pose.

- Refuel outdoors only and do not smoke while re fu -

el ing.

- Add fuel before starting the engine. Never remove

the cap of the fuel tank or add petrol while the engine

is running or when the en gine is hot.

- If petrol is spilled, do not attempt to start the engine

but move the ma chine away from the area of spillage

and avoid cre at ing any source of ig ni tion until petrol

va pors have dis si pat ed.

- Replace all fuel tanks and container caps se-

cure ly.

• Replace

faulty

silencers.

• Before using, always visually inspect to see that the

blades, blade bolts and cutter assembly are not worn

or dam aged. Replace worn or damaged blades and

bolts in sets to pre serve balance.

• On multi-bladed machines, take care as rotating one

blade can cause other blades to rotate.

III. Operation

• Do not operate the engine in a confined space where

dan ger ous carbon mon ox ide fumes can collect.

• Mow only in daylight or in good artificial light.
• Avoid operating the equipment in wet grass, where

feasible.

• Always be sure of your footing on slopes.
• Walk, never run.
• For wheeled rotary machines, mow across the face of

slopes, never up and down.

• Exercise extreme caution when chang ing direction on

slopes.

• Do not mow excessively steep slopes.
• Use extreme caution when reversing or pulling the

lawnmower towards you.

• Stop the blade if the lawnmower has to be tilted for

trans por ta tion when cross ing surfaces other than grass,

and when transporting the lawnmower to and from the

area to be mowed.

• Never operate the lawnmower with defective guards, or

without safety de vic es, for example deflectors and/or

grass catchers, in place.

• Do not change the engine governor settings or over-

speed the engine. Op er at ing the engine at excessive

speed may increase the hazard of personal injury.

• Disengage all blade and drive clutches before starting

the engine.

• Start the engine or switch on the motor carefully ac-

cording to instructions and with feet well away from

the blade.

• Do not tilt the lawnmower when starting the engine or

switch ing on the motor, except if the lawnmower has

to be tilted for starting. In this case, do not tilt more

than absolutely nec es sary and lift only the part which

is away from the op er a tor.

• Do not start the engine when standing in front of the

discharge chute.

• Do not put hands or feet near or under rotating parts.

Keep clear of the dis charge opening at all times.

• Never pick up or carry lawnmower while the engine is

running.

• Stop the engine and disconnect the spark plug wire:

- before cleaning blockages or un clog ging chute;
- before checking, cleaning or work ing on the lawn-

mower;

- after striking a foreign object. Inspect the lawnmower

for damage and make repairs before re start ing and

op er at ing the lawnmower;

- if the lawnmower starts to vibrate abnormally (check

im me di ate ly).

• Stop the engine:

- whenever you leave the lawnmower;
- before refuelling.

• Reduce the throttle setting during en gine shut down

and, if the engine is provided with a shut-off valve, turn

the fuel off at the conclusion of mowing.

• Go slow when using a trailing seat.

IV. Maintenance and Storage

• Keep all nuts, bolts and screws tight to be sure the

equip ment is in safe work ing condition.

• Never store the equipment with petrol in the tank inside

a building where fumes may reach an open flame or

spark.

• Allow the engine to cool before storing in any enclo-

sure.

• To reduce the fire hazard, keep the engine, silencer,

battery compartment and petrol storage area free of

grass, leaves, or excessive grease.

• Check the grass catcher frequently for wear or de te -

ri o ra tion.

• Replace worn or damaged parts for safety.
• If the fuel tank has to be drained, this should be done

outdoors.

Safe Operation Prac tic es for Pe des tri an-Controlled Rotary Lawnmowers

IMPORTANT: This cutting machine is ca pa ble of am pu tat ing hands and feet and throwing objects.

Failure to observe the following safety instructions could result in serious injury or death.

Advertising