JVC HR-E249E - Manual (Page 11)

EN
11
ENTER SHOWVIEW
NUMBER
4
Press OK, and a cursor
appears above “GUIDE
PROG”. Then, using the
NUMBER keys, input the
S
HOW V IEW number (found
in most TV listings) of a
program scheduled to be
broadcast on each station
on the list from step 1,
starting at the top. If you
enter the wrong number,
press CANCEL to backspace
and input the correct number.
CONFIRM CHANNEL
POSITION NUMBER
4
5
Press OK and the display
under “TV PROG” begins
blinking.
If the blinking number
under “TV PROG” agrees
with the channel
position . . .
. . . press OK.
If the numbers do not
agree . . .
. . . input the channel position using PUSH JOG %fi or
the NUMBER keys, then press OK.
● If you input the S
HOW V IEW number of a program that
has already aired, “ERROR” appears on screen for a
few seconds. Input the correct S
HOW V IEW number.
● Repeat steps 4 and 5 as necessary.
CLOSE MENU
6
Press MENU and selection is complete.
If you already know the Guide Program number for a station . . .
1– After step 3, press PUSH JOG .
● The GUIDE PROG number begins blinking.
2– Enter the Guide Program number using the NUMBER keys
or PUSH JOG %fi, then press PUSH JOG .
● The TV PROG number begins blinking.
3– Enter the channel position using the NUMBER keys or
PUSH JOG %fi, then press PUSH JOG .
● Repeat 2 and 3 as necessary.
4– Press MENU.
When Using A Satellite
Tuner
Preparation
1– Connect the satellite tuner to the AV2 IN/DECODER
connector on the rear of your recorder.
2– Set "AV2 SELECT" to "AV2" (
੬
pg. 30).
To Record Satellite Broadcasts . . .
1– Select the appropriate channel on the satellite tuner.
2– Press NUMBER key "0" to set your recorder's input mode to
"AUX2".
3– Start recording (
੬
pg. 18, steps 3 – 5).
To Record Satellite Broadcasts Using S HOW V IEW Timer
Recording . . .
1– Perform Guide Program Number setting.
● In step 5 in the left column, press NUMBER key "0" to set
"TV PROG" to "AUX2".
2– Perform S HOW V IEW Timer Recording (
੬
pg. 24).
To Record Satellite Broadcasts Using Regular Timer Recording . . .
1– In step 6 on page 27, press TV PROG. +/– to set the channel
position to "AUX2".
NOTE:
When timer-recording a satellite programme, first set the
satellite tuner to the appropriate channel before the selected
programme begins and then set the satellite tuner's timer. If your
satellite tuner does not have a timer, leave it switched on.
GUIDE PROG SET
1 2 3 4 5
GUIDE PROG TV PROG
1 1
[0-9] =
[MENU] : EXIT
When entering a S HOW V IEW
number for ZDF
%
%
%
GUIDE PROG SET
GUIDE PROG TV PROG
2 2
[ 5∞] =
[MENU] : EXIT
Satellite
Tuner
Satellite Antenna
Ex. 1
Ex. 2
Satellite
Tuner and
Decoder
Rear View
TV Receiver
Aerial or Cable
AV2 IN/DECODER