Jackson 200LT - Manual (Page 42)

37
200 Series Technical Manual
7610-100-45-00 Rev. E (02/10/2006)
SECTION 6: PARTS SECTION
MOTOR ASSEMBLY
The 200 models covered in this manual come supplied with various wash motor assemblies (a wash motor assembly includes
the wash motor and the pump end), depending on the characteristics of the machine. To ensure that you order the correct wash
motor assembly for the model you are servicing, please refer to the following table:
Model Volts Hz Phase Wash Motor Assembly
200/200B/200LT/200S 208 60 1 06105-102-05-94
200/200B/200LT/200S 230 60 1 06105-102-05-94
200/200B/200LT/200S 208 60 3 06105-102-04-94
200/200B/200LT/200S 230 60 3 06105-102-04-94
200/200B/200LT/200S 460 60 3 06105-102-04-94
Important note: When servicing a wash motor, it is important to refer to the wiring schematic found on the motor, to ensure
that the motor is wired correctly. Different manufacturers of motors may not use the same wire color codes and therefore, your
new motor, which may have been built by someone different than who built your original motor, may not connect using the same
wires. Always refer to the wiring diagrams on the motor you are installing. If the motor you are installing has had the schemat-
ic removed, contact Jackson MSC immediately for technical support.
ITEM DESCRIPTION Mfg. No.
1 Motor, 208/230/460V, 1 HP, 1 Phase 06105-102-08-94
1 Motor, 208/230/460V, 1 HP, 3 Phase 06105-102-01-94
2 Adapter Plate 04730-801-00-00
3 O-Ring, Adapter Plate 05330-400-18-00
4 Mechanical Seal 05330-300-07-27
5 Impeller 04320-300-44-00
6 Pump Casing 04320-300-45-00
7 "Square Ring" Seal 05330-500-23-00
8 Flange, Suction Pipe 04320-300-43-00
9 Slinger Washer N/A
10 Washer (3 phase only) N/A
11 Screw, 1/4”-28 x 1/2” (3 pahse only) N/A
10
11