JVC GET0576-001A - Manual (Page 79)

ENGLISH
17 SETTINGS
Category Menu items Selectable settings, [reference page]
AUDIO
VOL ADJUST
Volume adjust VOL ADJ –05 —
VOL ADJ +05
(Initial: VOL ADJ
00) : Preset the volume adjustment level of each source (except
FM), compared to the FM volume level. The volume level
will automatically increase or decrease when you change
the source.
• Before making an adjustment, select the source you
want to adjust.
• “VOL ADJ FIX” appears on the display if “FM” is selected
as the source.
L/O MODE
Line output mode • SUB.W
• REAR
: Select if the REAR LINE OUT terminals are used for
connecting a subwoofer (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for
connecting the speakers (through an external amplifier).
SUB.W FREQ * 9
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH : Frequencies lower than 72 Hz are sent to the subwoofer.
: Frequencies lower than 111 Hz are sent to the subwoofer.
: Frequencies lower than 157 Hz are sent to the subwoofer.
SUB.W LEVEL * 9
Subwoofer level
SUB.W 00
— SUB.W 08 : Adjust the subwoofer output level.
(Initial: SUB.W 04)
BEEP
Keypress tone • BEEP OFF
• BEEP ON : Deactivates the keypress tone.
: Activates the keypress tone.
TEL MUTING
Telephone
muting • MUTING 1/
MUTING 2
• MUTING OFF
: Select either one which mutes the sounds while using a
cellular phone.
: Cancels.
AMP GAIN * 10
Amplifier gain
control
• LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
: VOLUME 00 – VOLUME 50
SRC SELECT
AM * 11
AM station
• AM OFF
• AM ON : Disable “AM” in source selection.
: Enable “AM” in source selection, [4].
AUX IN * 12
Auxiliary input
• AUX OFF
• AUX ON : Disable “AUX IN” in source selection.
: Enable “AUX IN” in source selection, [4].
* 9 Displayed only when “ L/O MODE” is set to “SUB.W.”
* 10 The volume level automatically changes to “VOLUME 30” if you change to “ LOW POWER” with the volume level
set higher than “VOLUME 30.”
* 11 Displayed only when any source other than “AM” is selected.
* 12 Displayed only when any source other than “AUX IN” is selected.
EN16-19_KD-R407[EE]f.indd 17 EN16-19_KD-R407[EE]f.indd 17 10/8/08 5:55:47 PM 10/8/08 5:55:47 PM