Jacuzzi J - 200 J - 280 - Manual (Page 18)

J-200
all north american J-210 Convertible Models (60 hz)
120V/15A† 240V/30A† 240V/40A ‡
Circuit Breaker: 15A†, 1-Pole 30A†, 2-Pole 40A ‡, 2-Pole
Number of Wires: 3 (15A GFCI
Cord US
Only*)
4 (Hard Wire
Only)
4 (Hard Wire
Only)
Frequency: 60 Hz 60 Hz 60 Hz
Current Draw: 12A 21A 30A
* all Canadian spas must be hard wired per Csa Canadian standards
(page 8).
† In 15A/30A configuration, the heater will not operate while the jets
pump is running in high speed. The factory setting is 120V/15A.
‡ In 40A configuration, remove jumper JP1-2 on the board, to allow the
heater to operate when the jets pump is running in high speed.
CauTIon (For 4-wire 240 vaC Heater operation): move the red
wire on the main terminal strip (TB1) from position #1 to position
#3. make certain wires are connected exactly as shown in Figure
D (page 18) before applying power. Failure to do so will result in
damage to the circuit board and/or related components and void
the manufacturer’s warranty.
export J-270 and J-280 models (50 Hz)
230V/20A* 230V/30A** 230V/40A***
Circuit Breaker: 20A * 30A ** 40A ***
Number of Wires: 3 3 3
Frequency: 50 Hz 50 Hz 50 Hz
Current Draw: 15A 23A 29A
* In 20A configuration, the heater will not operate while either jets
pump is running in high speed. This is the factory setting. Note:
pump 2 runs only in high speed.
** In 30A configuration, the heater will operate while one jets pump is
running in high speed. Note: pump 2 runs only in high speed.
*** In 40A configuration the heater will operate while both jets pumps
are running in high speed.
14