Jacuzzi J - 200 J - 280 - Manual (Page 35)

J-200
lock modes (l1-l2)
l1 Lock Out (disables all spa functions to permit filter
cleaning).
l2 Lock Mode (disables the jets and light buttons to
prevent unauthorized use of spa). Filtration/heating
cycle will continue to operate as programmed in
this mode. The temperature display flashes when this function is
enable. Example: the “F3” filtration/heating cycle was enabled prior
to choosing lock mode. The spa continues to perform the “F3” cycle
until lock mode is canceled, allowing another cycle to be selected.
Filter Cycle setup example
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. Example: If you desire your
first filtration/heating cycle to begin at 10:00 AM turn off power to the spa
and turn it back on again at 9:58 AM.
note: Start time is approximate and may vary slightly from day to day.
31