J-200, Warning – Jacuzzi J - 200 J - 280 User Manual

Page 26

Advertising
background image

J-200

10. Leave spa cover open during this step to allow

excessive chemical vapors to exit spa, protecting

pillows and plastic knobs from chemical attack. If spa

is indoors, open doors and windows for proper

ventilation. Turn on all jet pumps for one hour, then

place the massage selector knob in the center

“combo” position and open all air controls (Figure A is

for all models except the J-210). For the J-210

models (Figure B) turn the Diverter Jet in the “combo”

position.

note: You will need to press the jets pump button(s)

every 20 minutes since these functions have an

automatic 20 minute time-out function that turns them off.

warnInG:

rIsK oF personal InJurY!

To decrease the risk of injury, drowning or entrapment,

never leave your hot tub unattended for any reason while

the cover is open and accessible, especially to small

children and animals!

Precautions should be taken to minimize your exposure

to chemical vapors (that could cause lung, brain, or skin

damage).

!

11. Turn off power to the spa at the circuit breaker, then drain spa as

outlined in Section 12.2 “Draining And Refilling” (page 35).

12. Fill spa until water covers all jets but does not touch the bottom of

the lowest headrest. DO NOT OVERFILL.

CauTIon: To DeCrease BuIlD up on ComponenTs anD

mInImIZe aCrYlIC DamaGe.

Never fill with water from a water softener. If your water is extremely

“hard”, it is preferable to fill half-way with hard water and the rest of

the way with softened water. Water that is too soft can be corrosive

to metal components.

13. Consult your authorized Jacuzzi dealer for chemical

recommendations, then add chemicals to spa water to achieve a

constant sanitizer reading within the levels recommended by the

Association of Pool and Spa Professionals/USA printed on the inside

cover of this manual.

14. Turn on all jet pumps when adding chemicals to ensure proper

mixing and leave your spa cover open until the sanitizer level falls

below 4.0 ppm to protect pillows and plastic knobs from chemical

attack.

Air Control

Figure B

Figure A

A

B

C

22

Advertising