Initial setup, Set lock code, Auto demo – JVC AV 32DF74 User Manual
Page 36
Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes pre-
set with a lock code of “0000”. You may change the code to any four-digit number you wish. To
change the lock code, follow the steps below.
Press the M
ENU
button
π†
To SET LOCK CODE
è
To operate (lock icon appears)
Press Z
ERO
to access the lock code
The first digit will be highlighted
è
To select the number
π†
To move to the next digit
Continue to follow these directions for all four numbers
Press the OK button to finish (your lock code is now set)
Press the Menu button when finished
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
Notes:
���������
�������������
������ �������
����
����
��������������������
����
��
When a viewer attempts to watch a blocked channel,
this message appears:
The channel will remain blocked until the correct lock
code is entered (see above for information on setting
your lock code).
Initial Setup
36
Set Lock Code
������������������������
�������������������
�������������������������
������������������������
���������������������������
Auto Demo
This function lets you preview the many different viewing modes of your TV. It will cycle through
“Multi Screen Demo”, “Picture in Picture Demo”, all of the different “Aspect” ratios and all of the
different “Video Status” modes.
Press the M
ENU
button
π†
To AUTO DEMO
è
To turn AUTO DEMO ON or OFF
Note:
• To stop auto demo, press the M
ENU
button, and select auto
demo by pressing the π†
buttons, and turn it off by pressing
the
è
buttons. Press the M
ENU
button to finish.
����������������
���������������
������
�������������
���������
���
�������������
������
�������
����
����
���������
��������
AV-32\36DF74 English
6/4/03, 9:21 AM
36