JVC 1203TNH-II-IM - Manual (Page 37)

Channel guard and V-Chip settings are protected by a four-digit lock code. Your TV comes
preset with a lock code of “0000”. You may change the code to any four-digit number you wish.
To change the lock code, follow the steps below.
Press the M ENU button
π† To SET LOCK CODE
è
To operate (lock icon appears)
Press Z ERO to access the lock code
The first digit will be highlighted
è
To select the number
π† To move to the next digit
Continue to follow these directions for all four numbers
Press the OK button to finish (your lock code is now set)
Press the Menu button when finished
• After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.
Notes:
When a viewer attempts to watch a blocked channel,
this message appears:
The channel will remain blocked until the correct lock
code is entered (see above for information on setting
your lock code).
Initial Setup
37
Set Lock Code
LOCK CODE
SET LOCK CODE
SELECT OPERATE EXIT MENU
PRESS TO FINISH
0000
OK
THIS PROGRAMMING EXCEEDS
YOUR RATING LIMITS.
PLEASE ENTER LOCK CODE BY
10 KEY PAD TO UNLOCK IT.
NO. - - - -
Auto Demo
This function lets you preview the many different viewing
modes of your TV. It will cycle through “Multi Screen Demo”,
“Picture in Picture Demo”, all of the different “Aspect” ratios
and all of the different “Video Status” modes.
Press the M ENU button
π† To AUTO DEMO
è
To turn AUTO DEMO ON or OFF
Note:
• To stop auto demo, press the M
ENU button, and select auto demo by pressing the π†
buttons, and turn it off by pressing the
è
buttons. Press the M ENU button to finish.
INITIAL SETUP
SELECT OPERATE EXIT MENU
NEXT PAGE
PREVIOUS
AUTO TUNER SETUP
CHANNEL SUMMARY
V-CHIP
SET LOCK CODE
AUTO DEMO OFF
LT-26WX84 Eng (with stand) 37 12/11/03, 10:01:08 AM