JVC FS-8000 - Manual (Page 7)

4
Engli
s
h
CAUTION: Make all connections before plugging the System into an AC power outlet.
1. Open the Speaker terminals on the rear of the Unit, and on the Speakers themselves.
2. Connect the speaker cords between the terminals as shown below.
Connect the cords with a black line to the (–) terminals and cords without a black line to the (+) terminals.
Close each of the terminals to securely connect the cords.
Right speaker (rear side) Left speaker (rear side)
CAUTION: A TV may display irregular colors if located near the speakers. If this happens, set the speak-
ers away from the TV.
Removing the speaker grilles
The speaker grilles can be removed. When attaching the speaker grille
When removing,
1. Insert your fingers at the top and pull towards you.
2. Also pull the bottom towards you.
CAUTION: Note for installation
•
Take special care to select an appropriate installation place where an earthquake or shock does not cause the unit to collapse or drop on the
floor.
SP-FS8000
Attach the supplied spacers to the bottom of the unit
to protect the cabinet, prevent slipping, and absorb the
cabinet vibration.
Peel off the backing from a spacer and attach it.
Connect the signal cord between the SUB WOOFER OUT terminal of the Unit and the LEFT/MONO INPUT terminal of the Powered Subwoofer.
Connecting the Speakers
Connecting the Powered Subwoofer
Marked with a black line
SPEAKER CORD
Speaker grille
Spacer
Backing
SUB
WOOFER
OUT
Powered Subwoofer
Signal cord