Jura Capresso 65349R3 - Manual (Page 13)

beans (all coating and flavors contain sugar or sugar substances).
Such coating can damage the burrs. Using such beans voids the
warranty. Have your coffee store grind the sugar coated beans
and use as described in the ground coffee funnel (chapter 20).
Please note: If you like flavored coffees we recommend to add
flavors to your coffee after brewing. This way you can use your
regular coffee beans in the bean container. Adding the flavors
after brewing lets you control the intensity much better than with
pre-flavored coffee. Your local coffee store typically carries a
variety of flavors.
• Open the Cover Lid (Fig.1,1).
Please note: The cover lid is spring activated. Push slightly
upwards on the right side finger indent and the lid will auto-
matically open.
• Remove the see-through Bean Container Safety Lid (Fig. 4).
Make sure the bean container is empty and clean. Fill beans
into the bean container. Replace the Safety Lid.
Attention: the machine will not work without the Safety Lid in
place. Close the Cover Lid.
Frozen Beans: Thaw 3 to 4 hours before adding to bean
container. This prevents moisture from seeping into the grinder.
Oily Beans: Beans with an oily surface tend to stick together.
This may prevent a continuous flow of beans from the bean
container into the burrs. As a result the grinder does not grind
enough coffee and you might get weak or no coffee at all.
Stir the beans in the bean container just before grinding.
Alternatively, you can also pour the beans in an open bowl and
let them sit for about 5 hours. The oils will evaporate (this will
not change the taste of your coffee). Then fill the beans into the
bean grinder. Now beans will feed into the burrs more easily.
6c. TURNING THE MACHINE ON
• Press the Main Power Switch at the bottom left in front of
the power cord (Fig. 3a). The On/Off button on top of the
machine illuminates (Fig. 3).
• Push the On/Off button on top of the machine. The display
will illuminate. PRESS RINSE . The Rinse Button (Fig. 3)
illuminates in blue.
• Place one cup underneath the Hot Water Spout (Fig. 1,6) and
one cup underneath the Auto Cappuccino System (Fig. 1,13).
• Push the Rinse Button. SYSTEM FILLS . The machine starts
pumping water into the system, until some water will come
through the cappuccino nozzle and the hot water spout.
During this operation the Rinse Button flashes.
WELCOME TO JURA
UNIT IS HEATING
PRESS RINSE
• Place a cup underneath the Dual Coffee Spouts (Fig. 1,5) and
push the Rinse Button. The machine will pump a bit of hot
water through the coffee spouts and will stop automatically.
COFFEE READY
• Place a cup underneath the Dual Coffee Spout and push the
1-cup Espresso Button (Fig. 3). The machine starts grinding
and brewing. The display might show
FILL BEANS .
• Push the 1-cup Espresso Button again. Discard the first two
cups of coffee. Your next cup will be perfect.
Important: After the initial set up we recommend to leave the
Main Power Switch on for the next 24 hours. This will give the
13.