Jura Capresso 65349R3 - Manual (Page 25)

25.
To activate one of the above programs, push the Rotary Dial
and follow the instructions on the display.
Please note: If you do not select any of the Maintenance
Programs, the display will return to
COFFEE READY .
26.2 TEMPERATURE
You can set the coffee temperature for the Cappuccino Button,
the Special Coffee Button and the four coffee buttons on the
right side to LOW, NORMAL or HIGH. The factory setting for
these buttons is HIGH. The temperature difference between
LOW and HIGH is approx. 7º F.
Please note: the temperature also depends somewhat on the
fineness setting of the grinder (chapter 7). The finer the grind the
slower the water will pass through the coffee causing it to get
somewhat hotter.
Changing the temperature:
COFFEE READY
• Push and hold the Rotary Dial until you hear a beep and the
display shows FILTER .
• Turn the dial until the display shows:
TEMPERATURE
a. Push the Rotary Dial. SELECT PRODUCT .
b. Push the beverage button for which you want to change the
temperature, e.g. the 1-cup Espresso Button. The display
shows
1 ESPRESSO HIGH .
c. Turn the Rotary Dial and select NORMAL (example).
d. Push the Rotary Dial to confirm. CONFIRMED ✔
e. TEMPERATURE . To change another beverage button start
with a. again.
26.3 COFFEE STRENGTH / AROMA
You can set the coffee strength for the Cappuccino Button, the
Special Coffee Button and the four coffee buttons on the right
side to
XMILD , MILD , NORMAL , STRONG , XSTRONG . For
factory settings see chapter 5. In XMILD the 1-cup buttons
grind for about 4 seconds, in XSTRONG for about 8 seconds.
The 2-cup buttons grind between 7 and 10 seconds respectively.
The minimum amount of coffee to be ground is approx. 5 grams,
the maximum approx. 16 grams.
Please note: the amount of ground coffee also depends on the
fineness settings of the burr grinder. The coarser the setting the
more coffee is ground through the burrs.
COFFEE READY
• Push and hold the Rotary Dial until you hear a beep and the
display shows FILTER .
• Turn the dial until the display shows: AROMA
a. Push the Rotary Dial. SELECT PRODUCT .
b. Push the beverage button for which you want to change the
coffee strength, e.g. the 2-cup Coffee Button. The display
shows
2 COFFEE NORMAL .
c. Turn the Rotary Dial and select XSTRONG .
d. Push the Rotary Dial to confirm. CONFIRMED ✔
e. AROMA . To change another beverage button start with a.
26.4 CAPPUCCINO PROGRAMMING
Chapter 25.2 explains how to change the pre-sets for milk and
the coffee volume while the Z5 is brewing. In programming you
can simply change the pre-sets by changing the values shown in
the display without making the beverage.