John Deere HR1250E1 - Manual (Page 33)

Operator’s Manual 33
Specifications
SPECIFICATIONS
ITEM SPECIFICATION
Water Pump ................................................................... 1.75 GPM (6.62 L/min)
1250 PSI (86 Bar) (8613 kPa) at pump
1100 PSI (76 Bar) (7579 kPa) at discharge fitting
Electric Motor ................................................................. 120 volts, 13.5 amps, single phase, 60 Hertz, 1.5 HP,
1725 RPM, thermal-protected manual reset.
Electrical Power Requirements ...................................... Voltage at power supply with washer running must be
greater than 108 VAC.
Water Supply Requirements .......................................... Inlet water supply pressure - 20 PSI (1.4 Bar) minimum
Inlet water supply volume - 3 GPM (11.4 L/m) minimum
Inlet water supply hose - 5/8 in. (15.9 mm) minimum I.D.
50 ft. (15.2 m) maximum length
Discharge Hose ............................................................. 25 ft. x 3/8 in. (7 m x 6.4 mm) minimum 3000 PSI (207 Bar)
working pressure, acid and oil resistant
Power Cord .................................................................... 35 ft. (10.7 m), 14 gauge, 3 conductor, water resistant,
with ground fault circuit interrupter (GFCI).
Nozzle Wand .................................................................. Nozzle size -- .047 in. (1.2 mm)
Color of dot - Yellow
RECORD SERIAL NUMBER
Write you model number, machine serial number (see
serial number tag (A) in illustration) and date of purchase
in the spaces provided below. Your dealer needs this
information when ordering parts.
Model No. ______________________________________________
Machine Serial No. _______________________________________
Date of Purchase ________________________________________
(To be filled in by purchaser)
A