JVC GR-X5EK - Manual (Page 11)

EN
11 GETTING STARTED
MasterPage: Start_Right
GETTING
ST
AR
TED
a AC Adapter AP-V17E or AP-V14E
b Power Cord (only for AP-V14E)
c Battery Pack BN-VF707U
d S-Video/Audio/Video Cable
e USB Cable
f Audio Extension Cable (for optional
microphone, see page 12 for connection)
g Audio Extension Cable (for optional
headphone, see page 12 for connection)
h Core Filter [large] (for USB cable, see page
12 for attachment)
Core Filter [large] (for power cord, only for
AP-V14E, see page 12 for attachment)
i Core Filter [small] x5 (for S-Video/Audio/
Video cable, audio extension cable and AC
adapter’s cord, see page 12 for attachment)
j CD-ROM
k Remote Control Unit RM-V720U
l Lithium Battery CR2025* (for remote control
unit)
m Memory Card 32 MB (already inserted in the
camcorder)
n Shoulder Strap (see the right column for
attachment)
o Lens Cap and its string (see the right column
for attachment)
p Battery Mount Cover** (already attached on
the camcorder)
q Cable Adapter
r Lens Hood (see below for attachment)
* A lithium battery is pre-installed in the remote
control unit at time of shipment (with insulation
sheet). To use the remote control unit, remove the
insulation sheet.
** Attach the battery mount cover to protect the
battery connector when the battery pack is
removed. For the attachment/detachment, refer to
“Charging the Battery Pack” (
੬ pg. 13).
NOTES:
● In order to maintain optimum performance of the
camcorder, provided cables may be equipped with
one or more core filter. If a cable has only one core
filter, the end that is closest to the filter should be
connected to the camcorder.
● Make sure to use the provided cables for
connections. Do not use any other cables.
Attaching the Lens Hood
When shooting outside or in bright locations,
light can sometimes reflect within the lens and
cause a whitish haze to appear over the subject
(flare). To prevent flare and provide extra
protection for the lens, attach the lens hood to
the camcorder.
Rotate counterclockwise to remove it.
● Remove the lens hood when attaching a
conversion lens or lens filter. If this type of lens is
attached over the lens hood, the corners of the
image may be darkened (vignetting).
How to Attach the Lens Cap
To protect the lens, attach the provided lens cap
to the camcorder as shown in the illustration.
NOTE:
To confirm the lens cap is
on correctly make sure the
cap is flush to the
camcorder.
How to Attach the Shoulder Strap
Follow the illustration.
1
Thread the strap through the eyelet.
2
Fold it back and thread it through the strap
guide and the buckle.
● To adjust the length of the strap, loosen and then
tighten the strap in the buckle.
3
Slide the strap guide fully towards the eyelet.
Align. Rotate clockwise.
Place here during
shooting.
1
2
3
Strap guide
Buckle
Eyelet
GR-X5PAL.book Page 11 Thursday, April 7, 2005 7:23 PM