JVC GR-X5EK - Manual (Page 47)

EN
47 EDITING
MasterPage: Start_Right
AD
V
A
N
C
ED
F
E
A
T
UR
ES
It is also possible to copy recorded scenes from
the camcorder onto another video unit equipped
with a DV connector. Since a digital signal is
sent, there is little if any image or sound
deterioration.
To use this camcorder as a player
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit
equipped with a DV input connector using a DV
cable as shown in the illustration.
3
Start playback on the camcorder. ( ੬ pg. 20)
4
At the point you want to start dubbing, start
recording on the video unit. (Refer to the video
unit’s instruction manual.)
5
To stop dubbing, stop recording on the video
unit, then stop playback on this camcorder.
NOTES:
● It is recommended to use the AC adapter as
the power supply instead of the battery pack.
(
੬ pg. 14)
● If a blank portion or disturbed image is played
back on the player during dubbing, the dubbing
may stop so that an unusual image is not dubbed.
● Even though the DV cable is connected correctly,
sometimes the image may not appear in step 4. If
this occurs, turn off the power and make
connections again.
● If “Playback Zoom” (੬ pg. 24) or “Playback
Special Effects” ( ੬ pg. 24) is attempted or
SNAPSHOT is pressed during playback, only the
original playback image recorded on the tape is
output from the DV IN/OUT connector.
● When using a DV cable, be sure to use the
optional JVC VC-VDV204U DV cable.
To use this camcorder as a recorder
1
Make sure all units are turned off.
2
Connect this camcorder to a video unit
equipped with a DV output connector using a DV
cable as shown in the illustration.
3
Set the camcorder’s power switch to “PLAY”.
4
Set “REC MODE” to “SP” or “LP”.
( ੬ pg. 33, 38)
5
Press the recording start/stop button to
engage the record-pause mode.
● The “ ” indication appears on the screen.
6
Start playback on the player.
7
At the point you want to start dubbing, press
the recording start/stop button to start dubbing.
The
indication rotates.
8
Press the recording start/stop button again to
stop dubbing. The indication stops rotating.
9
Press 8 to return to the normal playback
mode.
NOTES:
● If no image is displayed on the LCD monitor, set
“S/AV INPUT” to “OFF”. ( ੬ pg. 33, 38)
● Digital Dubbing is performed in the sound mode
recorded on the original tape, regardless of the
current “SOUND MODE” setting. (
੬ pg. 34)
Dubbing to or from a Video Unit
equipped with a DV Connector
(Digital Dubbing)
Core filter
To DV IN/OUT
DV cable (optional)
To DV IN/OUT
Video unit equipped with DV connector
DV IN
GR-X5PAL.book Page 47 Thursday, April 7, 2005 7:23 PM