JVC GR-X5EK - Manual (Page 13)

EN
13 GETTING STARTED
MasterPage: Start_Right
GETTING
ST
AR
TED
This camcorder’s 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging the Battery Pack
1
Set the power switch to “OFF”.
2
With the arrow on the battery pack pointing
upward, push the battery pack slightly against
the battery pack mount.
● If the battery mount cover is attached, remove it
by sliding BATT. RELEASE.
3
Slide up the battery pack until it locks in
place.
4
Connect the AC adapter to the camcorder.
5
Connect the power cord to the AC adapter.
(AP-V14E only)
6
Plug the AC adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
7
When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC adapter from
the AC outlet. Disconnect the AC adapter from
the camcorder.
To detach the battery pack
While sliding BATT. RELEASE, remove the
battery pack.
* Provided
NOTES:
● This product includes patented and other
proprietary technology and will operate only
with JVC Data Battery. Use the JVC BN-
VF707U/VF714U/VF733U battery packs. Using
generic non-JVC batteries can cause damage
to the internal charging circuitry.
● If the protective cap is attached to the battery
pack, remove it first.
● Make sure to use the battery pack with the arrow
( ) mark. The camcorder does not turn on with the
battery mount cover without the arrow ( ) mark.
● When charging the battery pack for the first time
or after a long storage period, the POWER/
CHARGE lamp may not light. In this case, remove
the battery pack from the camcorder, then try
charging again.
● If the battery operation time remains extremely
short even after having been fully charged, the
battery is worn out and needs to be replaced.
Please purchase a new one.
● Since the AC adapter processes electricity
internally, it becomes warm during use. Be sure to
use it only in well-ventilated areas.
● Using the optional AA-VF7 battery charger, you
can charge the BN-VF707U/VF714U/VF733U
battery pack without the camcorder.
● After 5 minutes has elapsed in record-standby
mode with the cassette inserted, the camcorder
will automatically turn off its power supplied from
the AC adapter. In this case, the battery charge
starts if the battery is attached to the camcorder.
Using the Battery Pack
Perform steps 2 – 3 in “Charging the Battery
Pack”.
Maximum continuous recording time
* Provided
( ): When LCD backlight is off.
Power
A
POWER/CHARGE
Lamp
Battery pack
BATT. RELEASE
Open the cover.
Power Switch
mark
Arrow
Battery pack
mount
AC Adapter
(ex. AP-V17E)
To DC connector
To AC outlet
Battery pack Charging time
BN-VF707U* Approx. 1 hr. 30 min.
BN-VF714U Approx. 2 hr. 40 min.
BN-VF733U Approx. 5 hr. 40 min.
Battery pack Recording time
BN-VF707U* 45 min. (55 min.)
BN-VF714U 1 hr. 35 min. (1 hr. 55 min.)
BN-VF733U 3 hr. 45 min. (4 hr. 35 min.)
CONTINUED ON NEXT PAGE
GR-X5PAL.book Page 13 Thursday, April 7, 2005 7:23 PM