Loading/unloading a memory card, Pg. 17) – JVC GR-X5EK User Manual

Page 17

Advertising
background image

EN

17

GETTING STARTED

MasterPage: Start_Right

GETTING

ST

AR

TED

To protect valuable recordings
Slide the erase protection tab on the back of the
tape in the direction of “SAVE”. This prevents
the tape from being recorded over. To record on
this tape, slide the tab back to “REC” before
loading it.

NOTES:

● If you wait a few seconds and the cassette holder

does not open, close the cassette holder cover
and try again. If the cassette holder still does not
open, turn the camcorder off then on again.

● If the tape does not load properly, open the

cassette holder cover fully and remove the
cassette. A few minutes later, insert it again.

● When the camcorder is suddenly moved from a

cold place to a warm environment, wait a short
time before opening the cassette holder cover.

The provided memory card is already inserted in
the camcorder at the time of purchase.

1

Make sure the camcorder’s power is off.

2

Open the card cover (MEMORY CARD).

3

To load a memory card, firmly insert it with

its clipped edge first.
To unload a memory card, push it once. After
the memory card comes out of the camcorder,
pull it out.

● Do not touch the terminal on the reverse side of

the label.

4

Close the card cover.

To protect valuable files (available only for
SD Memory Card)
Slide the write/erase protection tab on the side
of the memory card in the direction of “LOCK”.
This prevents the memory card from being
recorded over. To record on this memory card,
slide the tab back to the position opposite to
“LOCK” before loading it.

NOTES:

● Some brands of memory cards are not compatible

with this camcorder. Before purchasing a memory
card, consult its manufacturer or dealer.

● Before using a new memory card, it is necessary

to format the card. (

੬ pg. 32)

ATTENTION:

Do not insert or remove the memory card while the
camcorder is turned on, as this may cause the
memory card to be corrupted or cause the
camcorder to become unable to recognise whether
or not the card is installed.

Loading/Unloading a Memory Card

Memory card

Card Cover (MEMORY CARD)

Label

Write/erase
protection tab

Clipped edge

GR-X5PAL.book Page 17 Thursday, April 7, 2005 7:23 PM

Advertising
This manual is related to the following products: