Jwin ILuv i903 - Manual (Page 12)

Noise-Canceling Headset w/ Bluetooth wireless technology V10M10_IM_EN_12072006
www.i-Luv.com - 11 -
Multi-function
button
OPERATING INSTRUCTIONS
Turning On/Off the i903 or Wireless Audio Transmitter (dongle)
To turn on the i903 and/or the included wireless audio transmitter (dongle), follow the
instruction below:
•
Please find the on/off switch located on the left
earpiece.
• Three way Switch functions:
(Position 1) OFF: Headset is off
(Position 2) Bluetooth: Bluetooth is in standby mode
(Position 3) N/C On: Noise Canceling feature
Activated
To Enable Bluetooth Feature on i903 Headset:
Once the headset is set to standby mode, you could activate the Bluetooth wireless
technology by pressing and holding the Multi-function button on the headset for
approximately three (3) seconds. The i903 headset will make a high-pitched beep.
Followed by blue blinking light, indicating the device has been turned on.
To Enable Bluetooth Feature on Wireless Audio Transmitter (Audio Dongle):
Press and hold the On/Off Button on the Dongle for three (3) Seconds, then you will see
a blue blinking light on the button, indicating device is on and Bluetooth feature is ready.
To turn off the i903’s Bluetooth feature or go into standby mode
Standby mode:
Press and hold the Multi-function button for five (5) seconds, then you will hear a beep
followed by red light flashing four times
OFF Mode:
You could simply use the On/Off button on the headset.
To Turn Off the Dongle:
Press and hold On/Off button for five (5) Seconds, you will see a red light flashes for four
times, indicating the device is off
Mini USB
port