Jwin ILuv i903 - Manual (Page 13)

Noise-Canceling Headset w/ Bluetooth wireless technology V10M10_IM_EN_12072006
www.i-Luv.com - 12 -
OPERATING INSTRUCTIONS
Pairing i903 with the Included Wireless Audio Transmitter (Dongle)
The i903 can be used with an audio device that is not designed to support Bluetooth
wireless technology using the supplied wireless audio transmitter (dongle). In order to
answer and place phone calls while using the dongle, it is important to pair the mobile
phone first. After pairing the mobile phone according to the previously-listed instructions,
follow these directions to set the pair the i903 with the dongle.
1. To set the i903 into pairing mode, make sure to turn on the switch located on the left
ear piece. Then press and hold the Multi-Function button for five (5) seconds.
2. Press and hold the On/Off button on the dongle for
approximately five (5) seconds.
3. Both i903 and Dongle will display flashing Blue and red
lights, indicating that both are in pairing mode.
4. Place the headset near the
dongle when both are in
pairing mode.
5. When the
alternating red
and blue blinking
lights on both
devices change
to a blue blinking
light ONLY,
pairing is
complete.
6. Plug the 3.5mm end of the dongle into the
headphone jack of an audio device and enjoy
music playback wirelessly through the i903
stereo headphones.
Note: Only the volume can be controlled on the
i903 when using the dongle. All other functions
(skip, stop, forward, etc.) must be controlled using
the controls on the audio device itself.