Jwin ILuv i903 - Manual (Page 14)

Noise-Canceling Headset w/ Bluetooth wireless technology V10M10_IM_EN_12072006
www.i-Luv.com - 13 -
OPERATING INSTRUCTIONS
Pairing i903 with your Mobile Phone or Audio Device
Before using this headset, make sure that it is paired
with a mobile phone and audio devices with Bluetooth
wireless technology. To pair with such a device, follow
the instructions below:
1. Please make sure the headset is at standby mode. If
i903 is currently turned on then press the Multi-
Function button for approximately five (5) seconds.
There will be a high-pitched beep with red light flashes
about 4 times and headset will go into standby mode.
2. Press and hold the Multi-function button for approximately five (5) seconds until the
red and blue lights blink alternately around the button. The headset is now ready for
pairing. (Note: Pressing the Multi-function button longer than five (5) seconds will
turn off the headset. If this fails, then turn off the headset and turn it on again by
holding the Multi-Function button for five (5) seconds for pairing mode)
3. Set your mobile phone or audio device to its pairing mode (phones and audio devices
with Bluetooth wireless technology will have their own pairing instructions. See
owner’s manual of the phone or device for these instructions).
4. Place the mobile phone or audio
device and the i903 close together
during pairing. The mobile phone
and most audio devices will detect
i903 and identify it, displaying the
model number i903.
5. Once the i903 has been identified, confirm as per
the instructions on the device. You will be required
to enter a password on the next screen.