JVC KD-G720 - Manual (Page 29)

* 1 When you stand the unit,
be careful not to damage the
fuse on the rear.
* 1 ઱቎৹ʹጅइçʮ˻ʿ࠱
๑ᖢנ௰ڄۘᎳീé
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealers or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
Removing the unit
Before removing the unit, release the rear section.
2
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
ϰ༬༬௏éׇ֤ϛᄮڸؼ˗
ʓࡒڄ࿌༱ڷΕʄյܓڄϯ༫ദҺéϨس઱Љ੕ᖅç׻ᄔ࠱Љᘕ਎ࢭ˔άڄཊऄçቁώJVC
ԆԾࡖᛏ˜ኀੋ׻਎ࢭ˔άաᏻ˙͌༿੕й
лϨس઱ʿ঻ᇧ׆Ϩщ͸ᇧϙϯ༫ʹጅçᏻቁϐतڄӑிʆ࢜գϯ༫é
Do the required electrical connections.
නм׿ᄔڄྐཔ௤૊é
Bend the appropriate tabs to hold the
sleeve firmly in place.
Ҿᛮጅೋڄߴдçӕ͙ࢭጅೋԕ֣Ϛᄭ
ڷػ˖é
؜։͵ጆ
Ϛ؛ֈʹጅۮçᏻઅʹጅ݈௰ڄ֣׆֜௤૊௰˜ᖑළé
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
ݝ࿌׿Εçઅղ̕ػ଍ܓӕ˾಍ʈ̿ᆥç೸݈ძᗌ
ϙનղ਴ώ͙؁ղ̕ӕ˾çʹጅᎲ˃؁̳é
When using the optional stay / ࠝ᎛Έ́ᆊނ
Screw (option)
ᒘീਐ᎚·ڄ
Stay (option)
̀ᆉށ᎚·ڄ
Fire wall
Վ̑ػ
Dashboard
ᄭڷػ
Install the unit at an angle of less than 30˚.
અʹጅϯ༫Ϛ˲ؠ 30˚ ڄԴܾé
When installing the unit without using the sleeve / ࠝˀՠΈ͚ࢮጆೌϰ༬͵ጆ
In a Toyota car for example, first remove the car radio and install the unit in its place.
̣ᕙΉ೻(TOYOTA) ԆԾ޴բ ࡛ζ֊̳ԆԾЂࡖጅç೸݈અʹጅ༫ʈմڏ̳ڄт໯é
* 2 Not supplied for this unit.
* 2 ʿᎲʹጅಏաé
Flat type screws (M5 × 8 mm) * 2
ͦᏃᒘീਐ (M5 × 8 mm) * 2 Pocket
ڏೋ
Flat type screws (M5 × 8 mm) * 2
ͦᏃᒘീਐ (M5 × 8 mm) * 2
Bracket * 2
Ёࣙ * 2
Bracket * 2
Ёࣙ * 2
Note : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are
used, they could damage the unit.
ٍิ !ӕʹጅϯ༫ϚЁࣙʕइçੀͫ՟·8 mmۂڄᒘീਐéϨ՟·ཫۂڄᒘീਐç๡๑ᖢʹጅé
ݮᄑ૜ਜ
• ۙᎴുጜᔄê
* ᐓފ߹и዗ለ૊Ꮓ֜෨и዗ለ૊ᏃݵѴ૊᙮͸ᇧ%
• ྑກˀ়ો௣ê
* ᐓފ෦и዗ለ૊ᏃݵѴ૊ʕ%
• ಚᑶወԆЊᑶࡗê
* ᐓފಙᑵ዇᎔̳዗ለ૊ᏃݵѴഠཔ%
• ᑶࡗ͜ॳê
* ᐓފಙᑵ዇᎔̳ၷʪݵѴ૊ϙ%
* ᐓފಙᑵ዇ڄͣ(L)è͆(R) ၷʪڄ࠷๨(–) ݵѴθψ૊ϙ%
• ዇ࡗʹᓿࡗᛐê
* ݈૊ϙၷʪႩԾԽݵѴ՟·ཛഠ֜ཛ۹ڄྐለ௤૊%
• ͵ጆഛᇋê
* ᐓފಙᑵ዇᎔̳ၷʪݵѴ૊ϙ%
* ᐓފಙᑵ዇ڄͣ(L)è͆(R) ၷʪڄ࠷๨(–) ݵѴθψ૊ϙ%
• ͵ጆҭθˀ়ይіê
* ઱ݵѴʵ໩ࡌ໯઱ڄጅஇ%
Instal1-2_KD-G725_010A_1.indd 2 Instal1-2_KD-G725_010A_1.indd 2 13/12/05 11:41:03 AM 13/12/05 11:41:03 AM