Document Outline

• DECLARATION OF CONFORMITY
• BZSAFE.PDF
  • Safety Information
    • Introduction
    • Safety Equipment
    • Warnings and Cautions
      • Warnings and Cautions
    • Installation Safeguards
      • • Projector Weight
          • Do Not Tilt the Projector More Than 85 Degrees
          • Avoid Projector Angles of 15( to 23(
          • Maximum Projector to Screen Angle is 15(
    • Heat Safeguards
      • Fans
    • Light Safeguards
      • Ultra Violet and Infrared Light
      • Power Supply
    • Fluid Safeguards
    • Ventilation and Foreign Object Retrieval
• CH1INTRO.PDF
  • Introduction
    • Acronyms Used In Manual
    • 1.2 Safety
    • 1.3 Updates
    • 1.4 Hardware Compatibility
• CH2SYSDE.PDF
  • Functional Descriptions
    • Contents
    • Cover and Base
    • External Power Requirements
    • Electronics Systems Overview
    • System Power
      • System Power Supply
      • Arc Lamp Ignitor
      • High Voltage Power Supply
    • Card Cage
    • Circuit Boards
      • Raster Timing Generator Board (RTG) p/n 100568
      • Sync Generator
      • Sync Detector and Selector
      • Serration and Equalization Lockout
      • Phase Locked Loop
      • VSYNC Detector, Field Separator, and Mux
      • Adjustment Counters
      • Serial Communication
      • Raster Timing Generator I/O
      • Interlocks and Protection
        • Input
        • Output
        • Internal
      • Horizontal Deflection Board P/N 102523 (HDB)
      • Vertical Oscillator
      • Horizontal Phase Locked Loop
      • Horizontal Centering
      • Horizontal Power Supply
      • Flyback Switching
      • Geometric Correction
      • Output Section
      • Horizontal Sweep Failure Detection
      • Serial Communication
      • Horizontal Deflection Board I/O
      • Interlocks and Protection
        • Input
        • Output
        • Internal
      • Vertical Deflection Board P/N 102521(VDB)
      • Vertical Preamps
      • Vertical Amplifiers
      • Sweep Failure Detection
      • Side Pincushion and Keystone Correction
      • Horizontal Linearity Correction
      • Top and Bottom Pincushion and Keystone Correction
      • Correction Amplifiers
      • Serial Communication
      • General I/O
      • Interlocks and Shutdowns
        • Input
        • Output
        • Internal
      • Video Processor Board P/N 104672 (VPB)
      • Decoder
      • Video/Sync Mux
      • V & H Sync Strip
      • SG Sync Strip
      • B, G, and R Brightness and Contrast Amplifiers
      • On-Screen Switch
      • Gamma Correction
      • Switch Logic and Video Enable
      • RGB Sensitivity and Threshold Amplifier
      • ILA® Bias
      • Dynamic Focus Amplifier
      • Serial Communication
      • General I/O
      • Interlocks and Protection
        • Input
        • Output
        • Internal
      • Video Amplifier Board P/N 103567 or 103774 (VAB)
      • Video Signal
      • Failure Detection
      • Beam Current Sense
      • DC Restore
      • Arc Protection
      • Blanking
      • Enable Circuit
      • Focus
      • Filament Supply
      • General I/O
      • System Controller Board P/N 104668 (SCB)
        • Operator Interface:
        • Inter Board Communications and Control:
        • Projector operation:
        • Generate Overlays:
        • Provide Convergence Correction Outputs:
      • General Functional Description
      • CPU
      • Working and Compressed Memory
      • Expanded Memory
      • Correction Address Generator
      • DACs
      • DSP
      • Overlay Memory
      • Overlay Address Generator
      • Overlay Interface
      • LED Display Buffers and Logic
      • RS232 Interface
      • IR Interface
      • IIC Interface
      • Serial Interface
      • General I/O
      • Backplane Board p/n 100571
    • Optical Section
      • CRT Assembly
      • Relay Lens
      • Image Light Amplifier (ILA®) Assembly
      • Prism
      • Projection Lens
      • Arc Lamp Assembly
      • Optical Subassemblies
        • Cold Mirror
        • Ultraviolet Filter and Condensing Lens
        • Dichroic Mirrors and Down-Steering Mirrors
    • Image Light Amplifier
• CH3ADJST.PDF
  • Service Adjustments
    • Contents
    • Service (Cover-Off) Power-On Sequence
    • CRT Yoke Rotation
    • Vertical Size Tracking
    • Vertical Linearity Tracking
    • Horizontal Size Tracking
    • ILA® Bias Settings
    • CRT Mechanical Focus
    • Electronic Focus
    • Jumper Settings
      • Front/Rear Jumpers
      • Inverted Vertical Jumpers
    • G2 Adjustment
      • Sensitivity/Threshold Offset
      • G2 Setting
    • Arc Lamp Alignment and Focus
      • Model 330 Arc Lamp Alignment and Focus
      • Model 340SC and 370SC Arc Lamp Alignment and Focus
    • Arc Lamp Current Adjustment
• CH4MAINT.PDF
  • Maintenance Remove/Replace)
    • Contents
    • Introduction
    • Projector Covers
    • Ventilation Filters
    • Arc Lamp Assembly
      • Model 330 Ignitor and Arc Lamp Assembly (P/N 900611S) Removal
      • Model 340SC and 370SC Ignitor Assy/Arc Lamp Assy (P/N 104651 or 104120) Removal
      • Collimating (Condensing) Lens Adjustment
    • System Power Supply
    • Electronics Module
    • Cathode Ray Tube (CRT)
      • Model 330 CRT Removal
      • Model 340SC and 370SC CRT Removal
    • Video Amplifier Board (VAB)
    • CRT Yoke
    • High Voltage Power Supply (HVPS)
    • Card Cage (Printed Circuit Boards)
    • Image Light Amplifier Assembly
    • Projection Lens
    • (SCB) Socket Battery Replacement
    • Recommended Spares
• CH5TRBSH.PDF
  • Troubleshooting
    • Contents
    • General Information
    • Power-On Codes
      • • First Set
        • Second Set
    • Break Points
      • • Resetting the Projector
        • Break (Trap) Data from the Diagnostics Menu
    • Main Menu Structure
• HGLOSS.PDF
  • Glossary of Terms