JVC UX-G60 - Manual (Page 17)

15
3
Adjust the parameter.
4 Repeat steps 2 to 3 to adjust other parameters.
To erase the screen, press VFP again while holding SHIFT.
Setting the Clock
Without setting the built-in clock, you cannot use Daily
Timers (see page 33) and Sleep Timer.
• To correct a mis-entry during the process, press CANCEL
(while holding SHIFT) or CLOCK/TIMER (while holding
SHIFT). You can return to the previous step.
1 Activate the clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode is
selected.
2
Set the time.
• Adjust the hour, then the minute.
Now the built-in clock starts working.
To check the current clock time during play
Turning Off the Power Automatically
Auto Standby
When Auto Standby is in use, the A.STBY indicator lights
on the display.
When disc play stops, the A.STBY indicator starts flashing.
If no operation is done for about 3 minutes while the
indicator is flashing, the System turns off (standby)
automatically.
Sleep Timer
You can set the shut-off time so that you can go to bed
without turning it off yourself.
1 Specify the time (in minutes).
2 Wait until the set time disappears.
To check the time remaining until the shut-off time, press
SLEEP while holding SHIFT.
• If you press the button repeatedly, you can change
the shut-off time.
ENTER/SET
TV CH
TV CH
Remote
ONLY
INFO
CLOCK/TIMER
6
MP3
1
WMA
RND
3DPHONIC
BONUS TA
B PRO
PRGM
USB
D V D
MIC V.MASK C.VO
L-
(while holding...)
ENTER/SET
MONO
MP3
1
PL PG
WMA
RND PRGR.
3DPHONIC
B.S.P. BONUS
ST
TA NEWS INFO
AHB PRO
A.STBY
1 2 3
S.TURBO
SLEEP
PRGM
QP Link
USB
S V C D V D
MIC V.MASK C.VOICE
L-BANDIII AM FM
REC
REC
DISPLAY Source information
Clock Disc type
Remote
ONLY
A.STANDBY
3
(while holding...)
Canceled
On
SLEEP
2
10 20 30 60 90 120 150
(while holding...)
Canceled
UX-G60[U]_2.book Page 15 Tuesday, February 7, 2006 5:16 PM