JVC GET0114-001A - Manual (Page 18)

18
ENGLISH
Other convenient tape
functions
Skipping the blank portions on the
tape
You can skip blank portions between the tunes
(Blank Skip).
When this function is on, the unit skips blank
portions of 15 seconds or more, fast-forwards to
the next tune, then starts playing it.
• See also “Changing the general settings
(PSM)” on page 22.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
(PSM: see page 23.)
2
Press ¢ or 4 to select
“B. SKIP” (blank skip).
3
Press + to select “ON.”
Now Blank Skip is activated.
4
Finish the setting.
To cancel Blank Skip, repeat the same procedure
and select “OFF” in step
3 by pressing –.
Finding the beginning of a
tune
Multi Music Scan allows you to automatically
start playback from the beginning of a specified
tune. You can specify up to 9 tunes ahead of or
before the current tune.
During playback
Specify where (how many tunes ahead
of or before the current tune) the tune
you want is located.
Each time you press the buttons, the number
changes up to ±9.
When the beginning of the specified tune is
located, playback starts automatically.
Notes:
• While locating a specified tune:
– If the tape is rewound to its beginning, playback
starts from the beginning of that side.
– If the tape is fast-forwarded to the end, it is
reversed and played from the beginning of the
other side.
• In the following cases, the Multi Music Scan
function may not operate correctly:
– Tapes with tunes having long pianissimo
passages (very quiet parts) or non-recorded
portions between tunes.
– Tapes with short non-recorded sections.
– Tapes with high level of noise or humming
between tunes.
– Tapes with tunes recorded at low recording
levels.
Press ¢ to locate a tune
ahead of the current tune on the
cassette.
Press 4 to locate a tune
before the current tune on the
cassette.
EN17-19KS-FX742R[E_EX]f.p65 1/8/03, 5:08 PM 18