JVC GET0114-001A - Manual (Page 19)

19
ENGLISH
Playing the current tune repeatedly
You can play the current tune repeatedly
(Repeat Play).
1 Press MODE to enter the
functions mode while playing a
tune you want to repeat.
2 Press RPT (repeat), while still in
the functions mode, so that the
RPT indicator lights up on the
display.
When the tune has been played, the tape is
automatically rewound to the beginning of that
tune and the same tune will be played again.
To cancel Repeat Play, repeat steps 1 and 2
above again so that the RPT indicator goes off.
Note:
In the following cases, Blank Skip and Repeat Play
may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions during
tunes.
– Tapes with short non-recorded sections.
– Tapes with high level noise or humming between
tunes.
– Tapes with tunes recorded at low recording levels.
Lights up when Repeat Play is turned on.
Prohibiting cassette ejection
You can prohibit cassette ejection and lock a
cassette in the cassette compartment.
While pressing TAPE 23, press and
hold 0 (eject) for more than 2 seconds.
“NO EJECT” flashes on the display for about
5 seconds, and the cassette is locked and cannot
be ejected.
To cancel the prohibition and unlock the
cassette
While pressing TAPE
23, press and hold
0 (eject) again for more than 2 seconds.
“EJECT OK” flashes on the display for about
5 seconds, and the cassette is unlocked.
Note:
If you press
0 while cassette ejection is prohibited,
the cassette will not be ejected.
EN17-19KS-FX742R[E_EX]f.p65 1/8/03, 5:08 PM 19