Jacuzzi K272000AF 7/06 - Manual (Page 19)

E
N
G
L
IS
H
INTEGRAL SKIRT MOUNTING DETAIL
FINISHING
MATERIALS
SKIRT
PANEL
CAULKING BEAD
U FRAME SKIRT MOUNTING DETAIL
SECURE BOTTOM OF FRAME TO FLOOR
FINISHING MATERIALS
FILLER (Optional)
CAULKING
BEAD
SKIRT
FRAME
SECURE SHELL CLIP
UNDER CENTER
BATH RIM
SKIRT
PANEL
SUPPORT FOR CORNER BATHS
H
2" x 4" STUD
APPLY
ADHESIVE
(50,8 mm x 101,6 mm)
Corner Baths with Skirt
If an optional skirt is used on a corner bath, additional support is
necessary in the front of the unit. Measure the height from the floor
to the underside of the bath rim. Cut two 2" x 4" studs, apply adhe-
sive to both ends and install (See specifications in ROUGHING-IN
REFERENCE
(CORNER) ).
Skirts
19
Jacuzzi Whirlpool Bath K272000AF 7/06
Removable Skirt Panel
Removal and Installation
To remove panel, grab a top corner of access panel and pull outward
to release the first Dual Lock fastener. Then work around the
perimeter pulling access panel outward to release the remaining
dual Lock fasteners.
To reinstall, align access panel such that the Dual Lock fasteners
on the access panel match to the Dual Lock fasteners on the tub
skirt. Engage each Dual Lock pair until all are snapped into place.
PEEL BACK CORNER
TO BEGIN DISCONNECTING
DUAL LOCK™ FASTENER
INSTALLATION INSTRUCTIONS