Jacuzzi K272000AF 7/06 - Manual (Page 5)

E
N
G
L
IS
H
Important: Read complete instructions before beginning installation.
Each whirlpool bath arrives ready for installation, completely equipped with motor/pump assembly and plumbing and fittings
necessary for whirlpool operation. An optional drain/overflow kit is available for installation on the bath.
Remove the bath from the carton. Retain the shipping carton until satisfactory inspection of the product has been made. Do
not lift the bath by the plumbing at any time; handle by the shell only.
Immediately upon receipt, inspect the shell before installing. Should inspection reveal any damage or defect in the finish, do
not install the bath. Damage or defect to the finish claimed after the bath is installed is excluded from the warranty. Jacuzzi
Whirlpool Bath responsibility for shipping damage ceases upon delivery of the products in good order to the carrier. Refer any
claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the published warranty informa-
tion packed with the product.
All bath units are factory tested for proper operation and watertight connections prior to shipping. NOTE: Prior to installa-
tion, the bath must be filled with water and operated to check for leaks that may have resulted from shipping damage
or mishandling. Jacuzzi Whirlpool Bath is not responsible for any defect that could have been discovered, repaired, or
avoided by following this inspection and testing procedure.
Not all tubs shown may be available as export units. Export tubs come with MANUAL controls and may come:
• with Pump/motor packaged separately ,
• with Pump/motor installed,
• with NO overflow cutout.
Because of the variety of export tub types some instructions may not apply to your unit. Disregard instructions that do not
apply to your specific tub.
BATHS WITHOUT INTEGRAL SKIRT
END VIEW
H
W
SIDE VIEW
L
2"
(51 mm)
BATHS WITH 3-SIDED TILE FLANGE
L
1"
(25 mm)
H
W
SIDE VIEW END VIEW
L
1"
(25 mm)
H
W
SIDE VIEW
BATHS WITH INTEGRAL SKIRT
END VIEW
SPECIFICATIONS (Rectangular) LH = Left Hand, RH = Right Hand
MODEL
PRODUCT
WEIGHT
OPERATING
GALLONAGE
TOTAL WEIGHT/
FLOOR LOADING DIMENSIONS
DRAIN/OVERFLOW
DIMENSIONS
SKIRT &
MOUNTING CUTOUT
HEATER READY
FOR FIELD
INSTALLATION
AMIGA™
LH & RH
72" (1829 mm) L
*
36" ( 914 mm) W
20-3/4" ( 533 mm) H
772 lb
(351 kg)/
43 lb/ft 2
(210 kg/m 2 )
50 U.S. gal
(186 liters)
105 lb
(48 kg)
16-7/8" (429 mm) A
14" (356 mm) B Optional,
U-Frame 70" x 34"
(1778 mm x
864 mm)
NOTE: The overall dimensions are nominal with a tolerance of +0 and -1/4" (6,4 mm).
FOR ALL UNITS: Electrical Service Requirements: All require a dedicated GFCI protected separate circuit.
(Optional) RapidHeat
TM : 115 VAC, 15 AMP, 60 Hz. dedicated GFCI protected separate circuit.
Motor/Pump: 115 VAC, 15 Amp, 60 Hz. dedicated GFCI protected separate circuit.
*Add 1/4" (6,4 mm) to this dimension when roughing-in for 3-wall niche.
BIANCA ©
LH
72" (1829 mm) L
*
48" (1219 mm) W
20-1/2" ( 521 mm) H
993 lb
(451 kg)/
41 lb/ft 2
(200 kg/m 2 )
73 U.S. gal
(276 liters)
135 lb
(61 kg)
16" (406 mm) A
8-1/2" (216 mm) B Optional,
U-Frame 70" x 46"
(1778 mm x
1168 mm)
AMIGA™
WITH INTEGRAL
SKIRT
LH & RH
72" (1829 mm) L
*
36" ( 914 mm) W
20-3/4" ( 533 mm) H
796 lb
(362 kg)/
44 lb/ft 2
(214 kg/m 2 )
50 U.S. gal
(186 liters)
129 lb
(59 kg)
16-7/8" (429 mm) A
14" (356 mm) B Integral NA
CETRA ©
WITH INTEGRAL
SKIRT
LH & RH
60" (1524 mm) L
*
32" ( 813 mm) W
20-1/2" ( 521 mm) H
727 lb
(330 kg)/
55 lb/ft 2
(268 kg/m 2 )
46 U.S. gal
(174 liters)
94 lb
(43 kg)
17-7/8" (454 mm) A
9-3/8" (238 mm) B Integral NA
CETRA © 536
LH & RH
60" (1524 mm) L
*
36" ( 914 mm) W
21-1/4" ( 553 mm) H
742 lb
(337 kg)/
50 lb/ft 2
(244 kg/m 2 )
48 U.S. gal
(181 liters)
92 lb
(42 kg)
Optional
U-Frame
58" x 34-1/4"
(1473 mm x
870 mm)
18-1/2" ( 470 mm) A
9"
( 229 mm) B
CETRA © 532
LH & RH
60" (1524 mm) L
*
31-7/8" ( 791 mm) W
21-1/4" ( 553 mm) H
697 lb
(317 kg)/
53 lb/ft 2
(259 kg/m 2 )
43 U.S. gal
(163 liters)
89 lb
(41 kg)
Optional
U-Frame
58" x 30-1/4"
(1473 mm x
768 mm)
18-1/2" ( 470 mm) A
9"
( 229 mm) B
RECTANGULAR BATHS
SPECIFICATIONS
Yes
(S750000 HEATER KIT)
Yes
(S750000 HEATER KIT)
Yes
(S750000 HEATER KIT)
Yes
(S750000 HEATER KIT)
Yes
(S750000 HEATER KIT)
Yes
(S750000 HEATER KIT)
5
Jacuzzi Whirlpool Bath K272000AF 7/06
DRAIN/OVERFLOW
A
B