JVC HR-J670EK - Manual (Page 31)

31
RF Cable
(provided)
21-pin SCART Cable
(not provided)
Player Your recorder Recorder Your recorder TV Receiver TV Receiver
RF Cable
(provided)
21-pin SCART Cable
(not provided)
VIDEO
CHAN-
NEL or
AV mode
VIDEO
CHAN-
NEL or
AV mode
NOTES:
● All necessary cables can be obtained from your dealer.
● When you select "EDIT" to dub tapes in step 3, be sure to
select "AUTO" (or "NORM" when "B.E.S.T." is set to "OFF")
after you finish dubbing the tapes.
● When you use this recorder as the player for editing, be sure
to set "O.S.D." to "OFF" before starting (
੬
pg. 33).
?
– –:– –
1 2 3
4 6 5
7 8 9
0
2
4
1
Edit To Or
From Another
Video
Recorder
You can use your video recorder as the source player or as the
recording deck.
MAKE CONNECTIONS
1
Connect the player’s 21-pin SCART connector to the
recorder’s 21-pin SCART connector as illustrated below.
When Using Your Video Recorder As The Source
Player . . .
. . . connect its AV1 (L-1) IN/OUT connector to the
recording deck.
When Using Your Video Recorder As The Recording
Deck . . .
. . . . connect its AV2 (L-2) IN/DECODER or AV1 (L-1)
IN/OUT connector to the source player.
SET RECORDING DECK’S
INPUT MODE
2
Set to AUX. With this video recorder, press AUX and/or
PR to select “L-1” for the AV1 (L-1) IN/OUT connector,
or “L-2” for the AV2 (L-2) IN/DECODER connector,
depending on the connector being used.
● When using the AV2 (L-2) IN/DECODER connector,
set "L-2 SELECT" to the appropriate mode. (
੬
pg. 32)
SET EDIT MODE
3
See "Picture Control" on page 29.
START SOURCE PLAYER
4
Engage its Play mode.
START RECORDING DECK
5
Engage its Record mode.
PR
AUX
Another recorder Another recorder
Recorder Player