JVC HR-J670EK - Manual (Page 44)

44
?
– –:– –
1 2 3
4 6 5
7 8 9
0
2
4
1
3
SUBSIDIARY SETTINGS (cont.)
Storing Channels Manually
To store channels that were not stored during Auto Set Up
(
੬
pg. 6), Preset Download (
੬
pg. 7) or Auto Channel Set
(
੬
pg. 42).
ACCESS MAIN MENU
1
Press MENU.
ACCESS CONFIRMATION
SCREEN
2
Press %fi to move the highlight bar (pointer) to
“MANUAL CH SET”, then press OK or
#
. The Confir-
mation screen appears.
SELECT POSITION
3
Press %fi @ #
until an
open position in which
you want to store a
channel begins blinking,
then press OK. The Manual
Channel Set screen
appears.
NUMBER
(Ex.) To store in position 6.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
5
5
PR CH ID PR CH ID
01 26 BBC1 08 – – – –
02 33 BBC2 09 – – – –
03 23 ITV 10 – – – –
04 30 CH4 11 – – – –
05 37 CH5 12 – – – –
06 – – – – 13 – – – –
07 – – – – 14 – – – –
[ 5∞ ]
= : EDIT
= [X] : DELETE
[MENU] : EXIT
OK
MENU
ATTENTION
Guide Program numbers are not set when channels are
stored manually. If an attempt is made at timer program-
ming with VIDEO Plus+ in this state, the “GUIDE PROG
SET” screen appears; set the Guide Program numbers on
this screen.
੬
“ATTENTION – Regarding Guide Program
Number Set” on page 17.
Or perform “Guide Program Number Set” (
੬
pg. 39).
The blueback screen and the
programme currently being
broadcast by the selected channel
appear alternately for 8 seconds
each.
SELECT BAND
4
Press %fi to change the
band between CH (regular)
and CC (cable), then
press
#
.
INPUT CHANNEL
5
Press the NUMBER keys to
input the channel number
you want to store.
● To input the registered
station name (ID –
੬
pg. 47), press
#
until
"– – –␣ –" (ID setting)
begins blinking, then
press
%fi.
● For fine tuning
adjustment, press
#
until "+/–" begins
blinking, then press
%fi. While tuning,
"+" or "–" appears.
● When "L-2 SELECT" is set to "L-2" or "SAT", the
"DECODER" setting cannot be changed (
੬
pg. 32).
ENTER NEW CHANNEL
INFORMATION
6
Press OK and the Confirmation screen appears.
● Repeat steps 3 through 6 as necessary.
CLOSE CONFIRMATION SCREEN
7
Press MENU.
● To change positions, see "Change Station Preset
Position" (
੬
pg. 45).
● If you wish to set station names other than the ones
registered in your recorder,
੬
"Set Stations (B)" on
page 46.
PR CH ID FINE DECODER
06 CH21 – –␣ – – +/– OFF
[ 5∞] : SELECT
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞ ∞
PR CH ID FINE DECODER
06 CH01 – –␣ – – +/– OFF
[ 5∞] : SELECT
[ ] : CURSOR +=
: OK
[MENU] : EXIT
∞ ∞